Lightolier instruction sheet IS8276, Instruction Sheet no, Circuittrack Systems

r

READ AND UNDERSTANDTHESE INSTRUCTIONSBEFORE INSTALLING FIXTURE ‘his fixture is intended for installation in accordancewith the National ElectricalCode and local emulationsTo. assure full compliance with local codes and regulations, check with your local electrical nspector before installation. To prevent electrical shock, turnoff electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

>

INSTRUCTION SHEET NO,

IS:8276

0892 Page 1 of 2

INSTRUCTIONS FOR ATTACHING LINEAR” ADAPTER TO LYTESPAN@ TRACK FOR USE WITH LYTESPAN BASIC OR ADVENT TRACK SYSTEM ONLY

INSTRUCTIONSFOR AllACHING LINEAR” TO SINGLE CIRCUITTRACK SYSTEMS

1.Insert into LYlESPAN TRACK (see Fig. 1). LOCKINGLEVERmust be on the same side of track as BEAD.

2.Rotate FITTING90° clockwise until LOCKINGLEVERsnaps and locks in place (see Fig. 2 and 3).

3.To remove: depress LOCKING LEVER, then rotate FITTING 90° counterclockwise.

YTESPANTRACK

FITTING

FIG. 1FIG. 2FIG. 3

INSTRUCTIONSFOR CONVERTINGFITTINGTO OPERATE ON 2	BRASSCON
CIRCUITTRACK SYSTEMS
See Fig. 4. BRASSCONTACTcan be raised or lowered. Broken line indicates
position for 1 circuit or lower circuit of 2 circuit track system.
To convert attachment FllTING for upper circuit of 2 circuit track, raise BRASS
CONTACT to high position by lifting CONTACT as high as stop permits and
CONTACT clicks into place.

LOCKING

LEVER

SEE BACK FOR LAMPING

1- I <>1-1TC> 14 E [2” ER’#E?lH’K~TR;;