Lightolier 8292 Instructions For Lamping A Powerarc Fixture, Is, Instruction Sheet No

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To assure full compliance with local codes and regulations, check with your local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:8292

0203 Page 2 of 2

INSTRUCTIONS FOR OPERATING AND LAMPING A POWERARC FIXTURE

INSTRUCTIONS FOR LAMPING A POWERARC FIXTURE:

1.	Turn off power to fixture.
2.	Remove the LENS by inserting finger into SLOT A and			POWER
	pressing the LENS in the direction of SLOT B (See FIG. 9). SLOT A
3.				INTERRUPT
	Carefully rotate LENS out of SLOT A in the direction shown			SWITCH
	in FIG. 10.	LENS	FIG. 9	SLOT B
4.	Slide glass out of SLOT B by pulling the LENS in the
	direction of SLOT A (See FIG. 11).
5.	To insert LAMP (70W CDM or CMH T-6 Double Ended
	Metal Halide M85), carefully push one end of the LAMP
	CONTACT into one end of the SOCKET CONTACT until
	the other end of the LAMP can be inserted into the
	opposite SOCKET (See FIG. 12).			LENS

FIG. 10

WARNING: ACCORDING TO MANUFACTURER’S INSTRUCTIONS, LAMP SHOULD BE INSERTED IN THE SOCKET WITH A MINIMUM ANGLE OTHERWISE BENDING FORCES WILL RESULT IN LAMP BREAKAGE. ALSO, INSTALL LAMP USING PROTECTIVE PAPER AND DO NO REMOVE IT UNTIL INSTALLATION IS COMPLETE. IF LAMP IS TOUCHED WITH BARE HANDS, CLEAN LAMP WITH DENATURED ALCOHOL AND WIPE WITH LINT FREE CLOTH.

6.Insure both LAMP CONTACTS are properly seated into the SOCKET CONTACTS (See FIGS. 12 & 13).

7.To re-insert LENS: First insert LENS in SLOT A (side with no switch), carefully push the LENS until you can set it flat into the face of the fixture. Make sure it presses the INTERRUPT SWITCH, then engage LENS into SLOT B.

WARNING: IF USED IMPROPERLY, THIS LAMP CAN CAUSE SERIOUS SKIN BURN AND EYE INFLAMMATION FROM SHORTWAVE ULTRAVIO- LET RADIATION. DO NOT OPERATE FIXTURE WITHOUT PROTECTIVE LENS IN PLACE. FIXTURE IS EQUIPPED WITH A POWER INTERRUPT SWITCH TO PREVENT LAMP FROM BEING ENERGIZED WHEN LENS IS REMOVED (SEE FIG. 9). DO NOT ATTEMPT TO DISABLE THIS DEVICE.

LENS	SLOT A
	SLOT B

FIG. 11

SOCKET

SOCKET CONTACT

FIG. 12

LAMP LAMP

CONTACT

SOCKET

FIG. 13

LAMP

®LIGHTOLIER a GENLYTE THOMAS company. 631 Airport Road, Fall River, MA 02720