Lightolier 9162 instruction sheet Is, Cord And Plug Connector, l,,1’\‘

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

lis fixture is intended for installation in accordance with the National Electrical Code and local regulations. ) assure full compliance with local codes and regulations, check with your local electrical inspector before stallation. Toprevent electrical shock, turnoff electricity at fuse box before proceeding.

T

INSTRUCTION SHEET NO.

IS:9162

Retain these instructions for maintenance reference.

0395 Page 1 of 1

CORD AND PLUG CONNECTOR

FOR USE WITH PROFILE TRACK SYSTEM ONLY

WARNING:

~INSTALL CORD AND PLUG CONNECTOR INTO THE TRACK BEFORE PLUGGING CORD INTO THE WALL RECEPTACLE.

~DO NOT USE ELECTRICAL CONNECTOR TO SUPPORT THE CORD. A SEPARATE SUPPORT FOR THE CORD MUST BE USED.

~DO NOT PIERCE CORD INSULATION WHEN MOUNTING IT TO A SURFACE.

o DO NOT ATTACH AN EXTENSION CORD TO THE CORD AND PLUG CONNECTOR.

~PLUG CORD INTO A POLARIZED RECEPTACLE ONLY. o DO NOT EXCEED 1200 WATTS ON THE TRACK.

A. INSTALLING IN-LINE SWITCH TO CORD.

1.Ensure POLARIZED PLUG is not plugged into a POLARIZED RECEPTACLE.

2.Follow the instructions included with the switch when mounting it to the CORD.

3.Install CORD and PLUG CONNECTOR into the track before inserting the POLARIZED

PLUG into the RECEPTACLE,

,&

B. INSTALLING CORD AND PLUG CONNECTOR INTO THE TRACK.

1.Point the POLARITY TAB away from the BEAD ON the track. 2, Insert ELECTRICAL CONNECTOR into track. Ensure CONTACT

BLADES insert into the GAP of the TRACK COPPER CONDUCTOR.

3.Tighten LOCKING SCREW.

—4, INSTAIJ.TRACK PER INSTRUCTION SHEET 9100

included with the track unit.

5. Support the cord taking care not to puncture the insulation.

~k

C. ENERGIZING CORD AND PLUG CONNECTOR.

1.Insert plug into a 120V. 60Hz polarized receptacle only.

2.THE WATTAGE ON THE TRACK MUST NOT EXCEED 1200

.==~%

~ /

II

l,,1’\‘

,’,!	coRD	/..	\
,’,{~~		?

WAllS.	Add	all	lamp wattages		on the track.	The sum	must be	.<>;,
under 1200. NOTE: For fixtures with magnetic Iowvoltage
transformers.		The	wattage	used	to calculate	the load	is as
follows: 75 watt lamp use 90 watts in calculation; 50 watt lamp
use 60 watts in calculation.
					CORD ANO PLUG CONNECTOR
			,---ILINENESWITCH (INCLUOED)
			/’	INSTALLATIONISOPTIONAL			,f–- .-
								1

-

‘-~ Lj.

—

\

,,p’

\-—— ——

—

\

POLARIZEDRECEPTACLE

ONE SLOT LARGERTHAN

THE OTHER.

LOCKING SCREW ~~

			TRACK BEAD -
				/
. . ...	- ..._r_	___
	.			=4=
\	, .———	—— —.-—..=.
				$~ .{-—.	~
	/—==.	. I	2
		*P,,	_
	>ql	.L2
	‘u
	._J___	_>_	.: ‘~:JL.. _____
		/’		+22:	-—T.-

POLARITYTAB

@ FALL RIVER MASSACHUSETTS, 02720

l-l C>1+~C>l-11= 1? MONTREAL QUEBEC, CANADA