READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To
assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:C7CW
A0604 |
| Page 2 of 2 |
INSTALLATION PROCEDURE FOR: C7CW SERIES 7” DIA. H.I.D. WALL CYLINDER
USED WITH C7E17VM, C7E17OVM, C7P38MH, C7E17PL, C7E17FL SERIES FLANGLESS
REFLECTOR TRIM (ORDER SEPARATELY)
WARNING: USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURERS’
REFLECTOR TRIMS MAY VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.
TO REPLACE BALLAST (Fig. 5 & 6)
Before changing the ballast, switch off the main power supply to the fixture.
STEP 1: Remove lamp.
STEP 2: Squeeze LAMPHOLDER SPRING while pushing upward to disengage from REFLECTOR.
STEP 3: For cylinder with optional Auxiliary lighting, detach AUXILIARY
ASSEMBLY SOCKET ASSEMBLY from REFLECTOR.
STEP 4: Remove WING NUTS, then separate UPPER HOUSING from top of LOWER HOUSING to access BALLAST/PLATE ASSEMBLY.
STEP 5: Turn SCREW at SUPPORT BRACKET counterclockwise to loosen
SUPPORT BRACKET. Repeat with other (2) screws. Carefully remove
BALLAST/PLATE ASSEMBLY from UPPER HOUSING.
STEP 6: Replace BALLAST, capacitor and ignitor (magnetic type ballast).
STEP 7: Reattach BALLAST/PLATE ASSEMBLY to UPPER HOUSING by tightening SCREWS until SUPPORT BRACKET locks onto UPPER HOUSING. Repeat with other (2) screws.
STEP 9: Align STUDS with holes in LOWER HOUSING, then firmly tighten | FIG. 5 |
with WING NUTS. |
STEP 10: Reinstall REFLECTOR. For additional instructions (if needed), see Reflector Trim Instruction Sheet.
A 
COMPANY
631 Airport Road, Fall River, MA 02720
