r
READAND UNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE
“hisfixture is intended for installation in accordana+with the National ElectricalCode and local
emulations. To assure full compliance with local codes and regulations, check with your local electrical
mpectorbefore installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTALLATION PROCEDURE OF LYTECASTER 1029 SERIES IN THE 1000PI
WARNING: READ MARKINGSINTRIMTO DETERMINELAMP
WAllAGE AND TYPE,ALWAYS USECORRECTLAMP.
1.FRAME-IN
2.ROTATE
Rotate (3)
3.TRIM INSTALLATION
A.Inserl SOCKET SPRING into SLOTS in neck of REFLECTOR. (Fig. B)
B.Push REFLECTOR TRIM straight up into ceiling opening until it is tight against ceiling.
C.Lamp fixture with recommended lamp wattage and type. (See wattage label,)
D.Vertical adjustment can be done by inserting a screwdriver into slot in YOKE, and using it as a lever, tilting the YOKE to the desired angle.
(Fig. C.)
E.Horizontal adjustment can be done by rotating LAMP/YOKE to desired
position.
NOTE:To remove Reflector Trim, turn Reflector Trim counterclockwise while pulling downward.
10OOP1 also accepts the following reflector Trims: 1005, 1008, 1010, 1011,
1012,1013, 1013BK, 1013WH, 1021,1022, 1023,1024,1035,1045, 1046, 1071, 1076, 1076WH, 1078, 1082, 1085, Rotate ROTO CLIPS so that the LONG LEGS extend inwardly toward the center opening.
WARNING:
LIGHTOLIERINC. USEOF OTHERMANUFACTURERS’FRAME-
IN KITSVOIDSTHE UNDERWRITERSLABORATORIESLISTING
AND COULDCONSTITUTEA FIREHAZARD.
INSTRUCTION SHEET NO.
IS:1029
0892
REFLECTOR TRIMS
SHORTLEG
LONGLEG (w[thReturn)
~ ROTOCLIP (4)
\$ \ ]:_
FIG. A
1- I
