5th page of 5 page section
G. Meat Grinder
To install the meat grinder (Figure 8):
1.Loosen the mounting bolt at the base of the meat grinder.
2.Line up the tang on the saw with the slot on the grinder (similar to a flat head screwdriver and a screw).
3.Push the meat grinder on the aluminum holder. Some twisting and turning may be necessary to slide it on; it is a tight fit.
4.Put the die in place and screw down the lock.
If you don’t intend to grind meat, don’t leave the grinder on the bandsaw. Meat juices are its lubrication and running dry will cause excessive wear.
Pestle
Lock
Meat Grinder
Casing Tube
Figure 8 shows the meat grinder installed with the casing tube in place.
VII. Assembly
H. Stand Enclosures
To install the stand enclosures:
1.Attach 6 plastic tabs to each plastic enclosure using the screws provided. Tighten them so they can still be turned by hand, without further adjustment with a screwdriver. Figure 9.
2.Position each stand enclosure as shown in Figure 9. Turn the plastic tabs so they keep the enclosures in place.
Plastic Tab
Stand Enclosure
Figure 9 shows a stand enclosure in place.
End of Section
Hunter’s Meat Cutting Bandsaw - 11 -
