VII. Assembly
5.Install the rubber feet. They should go through the 90° brackets first and then through the sides. Tighten securely.
B. Motor
1.Secure the auxiliary motor bracket to the stand top. Use carriage bolts, nuts, and washers. Figure 2.
2.Fasten the primary motor bracket to the left brace and the auxiliary motor bracket. Use carriage bolts, nuts, and washers. Do not fully tighten.
3.Mount the motor to the primary motor bracket using the hex bolts, nuts, and washers provided. Do not fully tighten.
4.Press the motor pulley over the motor shaft and insert the key in the keyway. Position the pulley so its
5.Now that the motor is mounted, tighten all the stand bolts but leave the motor bolts loose.
6.Flip the stand/motor assembly right side up on the floor. Hold the motor so it does not slide when you tip the stand over.
-8 - Hunters Meat Cutting Bandsaw
2nd page of 5 page section
7.If the stand is wobbly, check your floor first. If the floor is level, loosen the bolts and wiggle the stand until it rests firmly on the floor.
C. Bandsaw Unit
1.Lift the bandsaw onto the stand. The front of the saw must be on the same side as the switch.
2.Attach the bandsaw to the stand with the three (3) threaded studs. Screw them up through the stand top and into the welded nuts on the base of the bandsaw. Figure 3. It may be necessary to shift the band- saw slightly to get the studs lined up right.
3.Feed the short electrical cord through the plastic wire clamp in the motor junction box. Connect the wire according to the wire diagram insert included with this manual. Tighten the wire clamp. DO NOT
4.The longer cord from the base of the saw is the power cord. It is prefitted with a 110V grounded plug. NEVER
REMOVE THE GROUNDING PRONG!
Threaded Stud |
Welded Nuts |
Figure 3 shows the stud mounting locations. |
