Lightolier IS:1055LV Fs~, ==77=, Lamping Instructions Adjustmentilocking, Install Lamp

			LAMPING	INSTRUCTIONS	AND	ADJUSTMENTILOCKING
INSTALL		LAMP
5.	Remove		LAMP RING from LAMPIYOKE HOLDER		by	fs~
	pulling straight down (Fig. H).
6.	insert LAMP (MR-16) between LAMP SPRINGS until
	face	of	LAMP sits firmly on GLASS LAMP GUARD
						/.
	(Fig,	l).				-==77=.
7.	Attach		SOCKET to hi-in prongs	on LAMP (Fig. l).

s.Insert LAMP RING with LAMP and GLASS LAMP

GUARD attached	back into LAMP/YOKE	HOLDER	c
(Fig. J).
			GL4S&5L~MP
WARNING: LAMP	MANUFACTURERS	REQUIRE THE	FIG. H
GLASS IAMP GUARD BE IN PLACE BEFORE ENERGIZING
LAMP AND THAT GREAT CARE MUST BE TAKEN THAT

LAMP IS FULLY COOLED BEFORE RELAMPING. AVOID

FINGER MARKS WHEN HANDLING FOR THEY MAY CAUSE

~SHORT LAMP LIFE AND POSSIBLE BREAKAGE.

IS1055LV

0890

Page 2 of 2

LAMP

SPRING

I-44:

VERTICAUANGLE ADJUSTMENT AND LOCK (Figd) LAMP

9.krserl a screwdriver into the LOCKING GUIDE on the LAMP/YOKE HOLDER, and locate the clot in the VERTICAL ADJUST/LOCK SCREW, turn the SCREW

counterclockwise, and using the screwdriver as a lever, tilt the entwe UMPIYOKE HOLDER to the desired angle. Once the desired angle ie reached, tighten screw by turning screwdriver clockwise.

HORIZONTAL ADJUST AND LOCK (Fig. J)

10.The entire IAMPIYOKE HOLDER can be horizontally rotated to aim the an Ie of light as it leaves the hole in the APERTURE TRI% (Fig. J). This can be done by backing off the HORIZONTAL ADJUST/LOCK SCREW one full turn, freeing the SUPPORT PLATE (Fig J). Grasping the YOKES on either side of the LAMP/YOKE HOLDER, rotate the SUPPORT PUTE

to the desired angle and lock the position by tightening the HORIZONTAL ADJUST/LOCK SCREW.

RELAMPING: The locking mechanisms designed within this fixture allow ralamping without having to readjust and relock. Follow Steps 5-8.

NOTE 1. LOW VOLTAGE FIXTURES should be dimmed only with special dimmers Intended apeclfloslly for that purpose Use Lightoiier Lytemodej Soenlst, Cresoendo VA, Neptune VA,’ Preolelon VA, Essveet VA, Sunrise VA, Rediant VA or equlvelant pfidu6te by others or vsrisbie auto. transformer’e or eieotmnlo dimmers intended for use with low voltage flxturee. 2. Low voltsge fixtures msy produoe audible eound when used with externel dimmem which may be ob]ectional in acoustically critical eree%

GtiG~ARLMP

FIG. I

r LAMP

/

ET

.

DE

FIG. J

WARNING: USE ONLY REFLECTOR TRIMS PROVIDED By LIGHTOLIER INC. USE OF ~ER MANUFA~RERS’

RSFLECTDR TRIMS VOIDS THE UNDER~rERS LABORATORIES LISTING AND COULD CONSfTfUTE A FiRE HAZARD.