Lightolier IS:2005 specifications IS2005, Installation of Lytecaster Reflector Trim

lNsTR1-------- lcTlmJ., -..-, SI.IFFT,-- .,.Nn- \

INSTALLATION OF LYTECASTER REFLECTOR TRIM		IS:2005
IN THE 2000 SERIES FRAME-IN-KIT WITH ROTO CLIPS		1088
READ AND UNDERSTAND THESE INSTRUCTIONS	BEFORE INSTALLING FIXTURE.

This fixture is intended		for installation		in accordance		with	the National		Electrical	Code	and 10caI or fe&ral
code specifications.	To	prevent	electrical	shock,	turn	off	electricity	at	fuse box	before	proceeding,

Retain these instructions for maintenance referenoe.

FIG. A	FIG.	B	FIG. C	FIG. D
1. FRAME-IN	2. ROTATE	CLIPS	4. sNAP.ot4	4. PUSH-UP

WARNING: (RISK OF FIRE) DO NOT INSTALL INSULATION WITHIN 3 INCHES OF FIXTURE SIDES OR

WIRING COMPARTMENT, NOR ABOVE FIXTURE IN SUCH A MANNER TO ENTRAP HEAT.

1.FRAME-IN (Fig. A)

See Frame4n-Kit instruction Sheet for installation procedure,

2.ROTATE ROTO-CLIPS (Fig. B) As shown in Fig. E.

3.SNAPON (Fig. C)

Insert SOCKET CUP in neck of REFLECTOR, Make sure SPRINGS of SOCKET CUP snap into SLOTS of

REFLECTOR.

4.PUSH-UP (Fig. D)

Push REFLECTOR TRIM straight up until it is tight against ceiling.

NOTE To remove REFLECTOR TRIM turn REFLECTOR TRIM counterclockwise while !xllina downward.

f<

F

WARNING: USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER INC. USE OF OTHER MANUFACTURERS’ REFLECTOR TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

U.S. PATENT NOS, 4,029,822;4,313,754md 4,327,403

FOREIGN PATENTS PENDING.