Defiant Woodburning Stove
Assembly
Set Up Your Stove
Cast iron stoves are heavy, and it will take two to four people to move your Defiant into position.
Wipe the protective coating of oil from the griddle with a clean dry rag or a paper towel.
Install the handle on the griddle. Slip the bolt through a washer, a nylon bushing, then through the handle and the other bushing, then through the steel spacer and into the griddle tab. (Fig. 20) Tighten securely.
| Spacer |
Bushings | Knob |
| |
| Washer |
| Bolt |
ST536
Fig. 20 Attach the griddle handle.
Install Stove Legs
Remove and discard the four large
CAUTION: Overtightening can strip tapped threads.
Leg Bolt and Washer
Leg Leveller | ST466a |
|
Fig. 21 Attach the stove legs with leg levellers.
Storing the Handle
Use the removable handle to open or close the doors. After using it, remove the handle so it will not get hot. Store the handle in the handle holder installed behind the right front leg. (Fig. 22)
Bottom Heat Shield
Door Handle Holder
Leg Bolt and Washer | ST564 |
Fig. 22 Handle holder and heat shield positions.
Install the Optional Bottom Heat Shield
NOTE: The Bottom Heat Shield is required in most installations. Refer to Floor Protection, Page 10, for further details.
1.Remove the four
2.Screw the four 1¹⁄₄" spacers into the holes from which you removed the bolts,
3.Align the bottom heat shield against the spacers with the stepped side toward the rear of the stove.
4.Secure the shield with the four hex head bolts removed from the stove bottom previously. Tighten securely. (Fig. 23)
Spacers
ST537
Fig. 23 Attach the optional bottom heat shield.
30001693 | 17 |