INSTRUCTION SHEET FOR 9”,12”&16” PENDALYTE™ POWERHEAD
Note: This instruction sheet covers several luminaire styles. Powerhead assembly, lamp type, and reflector style may vary slightly from that shown, although installation is the same.
To wire POWERHEAD to suspension kit (Standard, Stem, and Deco suspension kits sold separately) follow instructions enclosed with individual suspension kit and connect as follows: Using wire nuts (local hardware item) connect black lead to hot (black) power lead, connect white lead to neutral (white) power lead, connect green/bare leads to ground (green) lead. METAL HALIDE FIXTURES: refer to wiring diagram in fig. 1.
CAUTION: MAXIMUM WATTAGE AS MARKED ON LUMINAIRE MUST NOT BE EXCEEDED.
CONNECT TO APPROPRATE VOLTAGE
|
|
|
|
|
|
277V |
|
|
|
|
|
|
|
|
|
| |
|
| BLACK |
| ||
240V |
|
| |||
208V |
|
|
| ||
|
|
| |||
120V |
|
|
| ||
POWERCORD
COMMONWHITE
GROUNDGROUND
HID BALLAST
Fig. 1
9”ALUMINUM REFLECTOR INSTALLATION
1.Locate
2.Align holes in ALUMINUM REFLECTOR with threaded holes in SPACER COLLAR. (Fig. 2)
3.Install
POWERHEAD |
SPACER COLLAR
9” GLASS SHADE INSTALLATION
CAUTION: Wear safety glasses. Glass is fragile. Handle with care. Broken glass may pose a personal safety hazard.
NOTE: Natural oils and soil may discolor and stain glass finish. Wearing clean cotton gloves is recommended.
1.Locate RETAINER CUP, GASKET STRIPS and
2.Support glass shade in place, align evenly with extruded collar, and align RETAINER CUP with THREADED INSERTS in socket plate.
3.Install
12”&16” REFLECTOR/REFRACTOR INSTALLATION
ALUMINUM REFLECTOR
SCREWS
Fig. 2
POWERHEAD
THREADED
INSERT 
GLASS
SHADE
1.Slide COLLAR up extruded NECK.
2.Peel off backing of FOAM GASKET and adhere to TABS on SOCKET MOUNT PLATE. (Fig. 4)
3.Tip Reflector/Refractor over SOCKET MOUNT PLATE and allow Reflector/Refractor to rest on
FOAM GASKET.
4. To secure Reflector/Refractor align SLOT in | POWERHEAD |
COLLAR over PINS and slide COLLAR down |
|
NECK. Twist COLLAR |
|
PIN to rest in NOTCH. |
|
ADHESIVE
BACKING
RETAINER CUP | GASKET |
| STRIPS |
| |
| SCREWS |
Fig. 3
12” REFRACTOR SUPPORT
CAUTION: 12” HID units with Acrylic Refractor must have REFRACTOR SUPPORT PLATE installed.
REFRACTOR SUPPORT PLATE and SUPPORT PLATE SCREWS ARE supplied with all 12” HID units.
1.Install Acrylic Refractor per instructions above.
2.Align REFRACTOR SUPPORT PLATE over SOCKET MOUNT PLATE. (Fig. 4)
3.Secure REFRACTOR SUPPORT PLATE with
SUPPORT PLATE SCREWS.
NOTCH
SLOT
COLLAR
PIN 
SOCKET
MOUNT
PLATE
REFRACTOR
SUPPORT
PLATE
NECK
FOAM
GASKET
TAB
SUPPORT PLATE SCREWS
Fig. 4
