INSTRUCTION SHEET NO.
IS:7586
B1197 | Page 2 of 2 |
Installation Instructions for Stem Mounting Kit
for use with Lytespan and ProSpec™ Track Systems Only.
B. MOUNTING TRACK ONTO STEMS
1.Loosen Screws on Track Clamps. In the stem used for power feed, the Track Clamps must be positioned as shown in Fig. 2.
Place Track Ribs (Fig. 4) between Track Clamps and side track into position. Make sure Bead (Basic and Advent only) (Fig. 4) of Track Units are in line with one another.
2.Run Supply Leads along top of track toward Live End. Loosen screw in Live End and remove from track.
3.Cut Wireway Cover to distance from Track Clamp to end of Track Unit. Slide Wireway Cover into track over Supply Leads (Fig. 2 and 4).
For ProSpec Feed track, place wire cover into track before attaching the stems to the track unit.
4.Remove Bottom Cover from Live End.
5.Break off Barrier in Live End by bending it back and forth (Fig. 3).
6.Pass Supply Leads through barrier opening in Live End. Insert Live End into Track Unit and tighten Screws (Fig. 2 and 3).
7.Connect Supply Leads to screw terminals as shown in Instruction Sheet IS:6020, IS:6121, for Advent), or IS:26000, IS:26046, IS:26050 for ProSpec. Ground terminal in Live End is not used when feeding power from a Stem.
8.Fasten Bottom Cover to Live End. Tighten Screws on all Track Clamps.
C. Instructions for Stem Extension Kit
1.Screw Coupling to threaded end of Stem (18" or 48" long) supplied with Stem Mounting Kit (fig. 5).
2.Screw Stem supplied with Stem Extension Kit to Coupling (Fig. 5).
3.Complete installation of Stem Mounted Lytespan Track following steps in section A and B.
Center Barrier | Track Rib | |||||||||||
| Wireway Cover | |||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Bead
Basic Track
Sidewall
Track Rib
Live End
Wireway Cover
Individual
Track Unit
Bottom Cover
Screw | Bead |
| |
Advent Track |
|
Barrier | Wireway Cover | Track Rib |
|
Barrier
Feed Track
| ProSpec Track |
Fig. 3 | Fig. 4 |
© 1997
Set Screws
Canopy
Screw Collar
Stem
(Stem Mounting Kit)
Screws
Track Clamps
Fig. 4
Stem Mounting Plate
Coupling
Supply Leads
