Lightolier LP-2 manual 1BHF

PG


Lighting Systems LP-2

1BHF

PG

-JOFBS
1FSG-ZUFÜ

DN
4PMJE
*OEJSFDU
-JHIU
5
1FS
'PPU
/PNJOBM
4FDUJPO

Module Ordering Information

Style	Series	Type
LP	1	A

Complete ordering instructions below.

2.5” (6.35cm)

9” (22.86cm)

						Half Scale
	Lamps		Length		Ballast	Options
	3T8
3T8 = 3-F32T8		4 = 4-Foot		U = Universal Voltage		Blank = No Options
		8 = 8-Foot		E = Emergency Pack		DS = A-B Switch
		12 = 12-Foot		D1 = Dimming 120v		X4 = 4 Wire for Dimming &
				D2 = Dimming 277v		Switched Emergency

Features

1.Housing: 18 gauge steel. Die-formed steel end cap with concealed access holes for through wiring. No exposed fasteners or hardware.

2.Lamping: Three T8 32 watt fluorescent lamps per 4-foot section. Center lamp is mounted diagonally. Provided by others.

3.Reflector: Precision die-formed CRS painted high reflectance white.

Electrical

Ballast is universal voltage, <10% THD, .88 ballast factor, instant start. 3 con- ductor, 18 gauge wire. Color-coded quick connectors allow ease of connection for joiner modules. For special circuiting consult factory. Cord is 18/3 SJT. Factory installed ballast disconnect allows the ballast to be disconnected from and reconnected to incoming power under load without turning the entire circuit off.

Dimming: 120/277 VAC 1% dimming level, 4 wire feed required.

Emergency Battery Pack: 32 watt: 450 lumens @ 90 minutes.

Mountings

Cable Suspension (not shown) - 4-1/2” (11.43cm) diameter flat canopy finished white enamel, 1/16” (0.16cm) diameter stainless steel aircraft cable adjustable up to 36” (91.44cm) without cutting.

Options

Dual Switching: Order the DS option for separate row switching. DS option automatically ships with the X4 option included.

4 Wire: Order X4 modules for remainder of the run when using dimming and/or switched emergency battery pack modules. Also, order the 4 Wire Cord Power Feed End Sets (LP1EC36X4) when using 4 Wire Modules.

Emergency Circuiting: Special circuiting - consult factory.

Ordering Information

Individual Fixtures:

1.Order number of MODULES required.

2.Order one POWER FEED END SET per MODULE.

Continuous Rows:

1.Determine run length.

2.Order the appropriate number of MODULES for the complete run.

3.Order one POWER FEED END SET per run.

4.Order one CABLE ASSEMBLY per MODULE minus one per run.

5.For runs that exceed amperage limits, order the appropriate number of SINGLE CABLE & CORD FEEDS.

Finish

Powder coated baked white enamel. Custom colors available, consult factory.

Labels

UL, cUL and I.B.E.W.

Job Information Type:

Job Name:

Cat. No.:

Lamp(s):

Notes:


"JSQPSU
3PBE
'BMM
3JWFS
."

t


t
'BY



We reserve the right to change details of design, materials and finish.

XXXMJHIUPMJFSDPN
½

1IJMJQT
(SPVQ
t #