Lightolier W7010 instruction sheet IS V7009I-too, A. Install Inside Reflector Fig, Instruction

T

							INSTRUCTION SHEET NO.
V7009.	V701O.		V7011				IS:V7009I-too
INSTALLATION OF CALCULITE A-LAMP WALL WASHER/DOWNLIGHT REFLECTOR							4
INSTRUCTION	SHEE1’ FOR ITEMS:
W7009;	W701O,		W7011				1Uuu
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance		with	the Nationai Electrical Code		and local or federal code			specifications. TO prevent
electrical shock, turn off electricity at fuse box before proceeding,
Retain these instructions for maintenance referance.
				—	LAMPHOLDER		SPRING
WALL WASHER
REFLECTUVHOUSING		—\	/	~	ADJUSTABLE	LAMPHOLDER		HOUSING

SPRING

DOWNLIGHT

BOX

	MOUNTING FRAME -	= CARDBOARD PAINT SHIELD
		FIG. 1
I	WARNING+RISK OF FiRE)DO NOT INSTALL1NSULATIONWITHIN3 lNCHESOF FIXTURESIDESOR
	WIRINGCOMPARTMENT,NOR ABOVEFIXTUREIN SUCH A MANNER SO AS TO ENTRAP HEAT.		1

A. INSTALL INSIDE REFLECTOR (FIG. 1)

NOTE For overlapping trim installation slip on WHITE TRIM RING over INSIDE REFLECTOR, as shown in Fig. 2 and 3. For flangeless trim installation, WHITE TRIM RING is not required.

To install INSIDE REFLECTOR in REFLECTOR/ HOUSING with THUMB SCREWS (Fig. 4), push INSIDE REFLECTOR up into REFLECl_OR/HOUSING. Rotate INSIDE REFLECTOR so that CUT OUT WINDOW is always opposite the wall to be lighted. Now, tighten the THUMBSCREWS so that INSIDE REFLECTOR is held firmly against ceiling surface.

INSIDE	(2
REFLECTOR ~
TRIM
		r
		J
WHITE		J
RING
FIG. 2		FIG. 3

B. CARE AND MAINTENANCE OF “A12AK” REFLECTOR

If handling of reflectors with anodized or Alzak finish is required, the use of clean white or plastic film gloves is recommended to avoid fingerprints.

Anodized or Alzak surfaces can be cleaned by the followina methods:

Wipe”of with a soft, clean, dry, lint-free cloth. Wipe off with a clean cloth dampened in mild detergent solution. Rinse, then wipe dry with lint-free cloth or paper towel.

WiDe off with a clean cloth damDened with a soiution of wetting agent and water (such as 2 oz. per gallon “Piuronic L62-LF by Wyandotte Products), or a liquid wax such as Glass Wax”. Then wipe dty. Avoid gritty cleaning agents.

‘HUMBSCREWTrREFLEmOR’HOus’NG

CUT OUT — 1	FIG. 4
WINDOW

U.S. Pat. No. 4,039,822