Lincoln Electric 10,000 PLUS Recommended Equipment, Stick, Wire Feed, TIG Welding, Plasma Cutting

C-2 ACCESSORIES C-2

RECOMMENDED EQUIPMENT

STICK

K704 ACCESSORY SET - Includes 35 ft. (10m) of electrode cable and 30 ft. (9.1m) of work cable, head- shield, work clamp electrode holder. Cables are rated at 400 amps, 100% duty cycle.

K875 Accessory Kit - For stick welding. Includes 20 Ft. (6.1m). #6 electrode cable with lug, 15 Ft. (4.6m) #6 work cable with lugs, headshield, filter plate, work clamp, and electrode holder and sample pack of mild steel electrode. 150 amp capacity.

WIRE FEED

K449 LN-25 - Includes internal contactor for across the arc operation (no control cable). Provides “cold” electrode until gun trigger is pressed. Includes gas solenoid.

K1870-1 LN-15 Across the Arc

Magnum Gun and Magnum Gun Connector Kit are required for gas-shielded welding. Innershield Gun is required for gasless welding.

K126-2Magnum 350 Innershield Gun (for LN-25, LN- 15).

K1802-1Magnum 300 MIG Gun (for LN-25, includes Connector Kit).

K470-2Magnum 300 MIG Gun (for LN-15, requires

K466-10 Magnum Gun Connector Kit).

K1500-1Gun Receiver Bushing (for LN-15, K126-2)

Note: See Wire Feeder IM Manual for appropriate Drive Roll & Guide Tube Kits.

TIG WELDING

K1783-9-PTA-26V TIG Torch.

KP509- Magnum Parts Kit and Argon gas.

K930-2-TIG Module.

Required TIG Equipment:

K938-1 Connector Kit

K936-4 Control Cable

K814 Arc Start Switch

Optional TIG Equipment:

K939-1 Docking Kit

K937-45 Control Cable Extension

PLASMA CUTTING:

K1580-1 Pro-Cut 55

Cuts mild steel using the 3-phase AC generator power from the engine driven welder. Accepts 3-phase or 1- phase input power. Requires the K1816-1 Full KVA adapter kit, if connected for 1-phase input power.

RANGER 10,000 PLUS AND RANGER 10,000