MAINTENANCE | ||
|
|
|
SAFETY PRECAUTIONS
WARNING
ELECTRIC SHOCK can kill.
•Unplug Miniflex before changing filter or replacing carbon brushes.
ROUTINE MAINTENANCE
•The aluminum collection pan should be inspected, cleaned and emptied on a monthly basis.
•The
•The
•Frequency of cleaning and emptying depends on a number of factors such as the type of welding process and the frequency of use.
•The main filter should be checked every month to ensure that there is no damage.
•The seals of the main filter should be checked every 12 months.
Refer to Figure D.1 on page
EMPTYING THE ALUMINUM COLLECTION PAN
1.Remove electrical cord of Miniflex unit from electri- cal outlet.
2.Loosen the side clips (A).
3.Remove the top cover (B) from the machine.
4.Remove
5.Remove
6.Empty the collection pan (D) and dispose of waste properly*.
7.Replace the
*Check with local authorities for regulations governing the proper disposal of used filters and particulate matter.
WARNING
The particulate matter collected in the unit may be dangerous to your health. Take necessary precau- tions so that you and your fellow workers do not breathe dust and particulate. Wear a suitable respirator when disposing of the particulate. Follow local Environmental regulations for disposal of filters and particulate matter.
REPLACING THE FILTERS
The main filter and the HEPA filter cannot be cleaned and therefore they have to be replaced periodically. It is recommended to replace all filters at one time.
WARNING
A saturated filter often contains dust and dirt particles which could form a health hazard upon inhalation. When replacing the filters, always wear a
Replace the filters in case of damage or when the extraction capacity has become insufficient due to the amount of particulate in the filter.
Periodic check of filters is required to maintain optimal performance and life of unit. Filter performance/life is dependent on variables such as:
Note: There is no filter clog indicator on this machine model.
Refer to Figure D.1 on page
Replacing/Cleaning the
1.Remove electrical cord of Miniflex unit from electri- cal outlet.
2.Loosen the side clips (A).
3.Remove the top cover (B) from the unit.
4.Remove
5.Remove the
6.Clean
7.Reposition the
(C) and reassemble unit.
MINIFLEX