Lindy 39632, 39636 5.2 CAT-32IP Setup Tool, MAC Address Detection, Authentication, IP Auto Configuration, DHCP, NONE, "pass, BOOTP, "super, Cancel, Section, Section, Net mask

Section 5 IP Access Configuration & Operation

5.2 CAT-32 IP Setup Tool

MAC Address Detection

Connect the CAT-32 IP to your computer either via a local network, or via USB. If you use a USB connection Windows will detect the CAT-32 IP as a ‘Removable Disk’ and an appropriate drive letter will be assigned.

Start the setup tool from the CD ROM.

A window opens as shown below:

On the upper left corner, the MAC address of the CAT-32 IP is displayed. To re-detect the MAC address, press the Refresh Devices button. The displayed MAC address should correspond to the printed address shown on the label on the base of the IP module.

On the lower right corner of the window, there are two buttons: Query Device and Setup Device. Press the Query Device button to display the preconfigured values of the network configuration. The values are displayed in the text fields located above. If necessary, adjust the network settings to your needs. To save the changes enter a user login and a password (see Authentication, below) and then press the Setup Device button.

Section 5 IP Access Configuration & Operation

Authentication

To adjust the authentication settings, enter your login as a super user and change your password.

Super user login

Enter the login name of the super user. The initial value is "super". All of the characters are lower case.

Super user password

Enter the current password for the super user. This initial value is "pass". All of the characters are lower case.

New super user password

Enter the new password for the super user.

New password (confirm)

Re-type the new password for the super user.

To close the window and accept the changes, press the OK button, otherwise press the Cancel button.

IP Auto Configuration

With this option, you can specify whether the CAT-32 IP should obtain its network settings from a DHCP or BOOTP server. From the drop down list select either DHCP or BOOTP. If you select NONE, the IP auto configuration is disabled and you should manually input the following network settings:

IP address

The IP address the CAT-32 IP uses.

Net mask

The net mask of the connected IP subnet.

Gateway address

The IP address of the default router for the connected IP subnet. If you do not have a default router, enter 0.0.0.0.

18 19