Section 5

IP Access Configuration & Operation

Remote Console Status LineStatus line

Shows both console and the connection state. The size of the remote screen is displayed. The example below was taken from a Remote Console with a resolution of 1024 x 768 pixels. The value in brackets describes the connection to the Remote Console. Norm means a standard connection without encryption, SSL indicates a secure connection.

Furthermore, both the incoming (In :) and the outgoing (Out :) network traffic are visible (in kb/s). If compressed encoding is enabled, a value in brackets displays the compressed transfer rate.

For more information about Monitor Only and Exclusive Access settings, see the relevant section 5.7.4.

Section 5

IP Access Configuration & Operation

5.7. Menu Options

Technological progress

The KVM over IP Module and its software and firmware are subject to technological progress and are being continuously upgraded accordingly. Therefore minor changes compared to the descriptions in this manual may be found, especially for the design of the screens and menus.

5.7.1. Remote Control

KVM Console

To open the KVM console, click either the menu entry on the left or on the console picture on the right. To refresh the picture, click on the Refresh button.

Remote Power

Future firmware updates will allow you to control external RS232 controlled power control distribution units. Please contact LINDY for further information regarding compatibility, connection and configuration of both LINDY and third party power control distribution units.

Should you wish to connect a remote power outlet then LINDY would recommend you to use IP managed power strips that can be found in the network section of the LINDY website, i.e. LINDY No. 32657, 32658, 32656, 32654, 32653, 32414, 32415

30

31