Features
Simple to Install
Right Hand
212LS –
212LS –
Left Hand
212LS –
212LS –
Easy to Maintain
User Codes - The 212LS lock recognizes up to 120 users with a different code for each, and the lockset retains codes without batteries. Codes can be one to six digits in length and digits can be repeated. The Master Code is always stored in user location one (1). A reset button is provided inside the lock which restores factory defaults and removes codes already stored. The lockset is equipped with an override mechanical key. The code toggles to allow passage for an event so any key will open the lock.
Security and Protection
Rugged Design
Lockset Parts List
1. | Spanner wrench | 11. | Interior Faceplate/Door |
2. |
| Handle w/battery case | |
| 12. | Interior Faceplate | |
3. | 13. | Override Keys (2) | |
| 14. | Pin Wrench (pries open key | |
4. | Strike Plate |
| slot cover) |
5. | Strike Plate Cover | 15. | Key Slot Cover |
6. | Latch/Strikeplate Screws | 16. | Screws: 2 sets Lock |
7. | Allen Wrench |
| Assembly screws (thick, |
8. | Exterior Door Handle/ |
| thin doors) |
| keypad | 17. | Sealing Washer |
9. | Exterior Gasket | 18. | Faceplate Assembly Nut |
10. | Interior Gasket |
|
|
|
|
| 4 |
1 | 2 | 3 | 6 |
|
| 5 | |
|
|
| |
7 |
|
|
|
8 |
|
| 12 |
10
911
13
14
15 | 16 | 17 | 18 |
Figure 1. Parts Diagram
Installation Steps
Door & Frame Prep
•Remove existing Lock from door
•If it is new door with no holes, use template provided
•Measure backset.
Installation
1.Unpack the lockset and inventory all parts. Remove mount- ing screws, separate lock assembly, and both interior/exterior handle plates and the two rubber gaskets.
2.Insert the strike plate hole cover (#5) and attach strike plate (#4) in the door jam/frame, securing with two Phillips head screws.
3.Install
4.Assemble locks inserting two Rubber Gaskets (#8, 9, 10, 11).
5.Thread battery wires through hole in Interior Faceplate/Door Handle (#11).
6.Attach Interior Faceplate/Door Handle (#11) to Exterior Door Handle (#8), securing with two short or long assembly screws. (#16)
7.Insert batteries and connect battery clip.
8.Secure Interior Faceplate (#12) with clear plastic washer with Nut (#17, 18)
9.Use spanner wrench (#1) to tighten nut (#15).
10.Program the system as described in this manual.
11.Instruct the users on lockset operation.
Manual Operation
•Use Pin Wrench (#14) to pull off cover (#15).
•Use override key (#13).
•Turn left twice.
P1345