CODE SWITCH MATCH
OPERATOR TERMINAL
MOUNTING TAB
24 VOLT 1
RELAY 2
COMMON 3
2 - WAY LUGS
WALL
BUTTON
ANTENNA
Figure 1
For remote installation the receiver may be mounted near the operator head on a joist or the ceiling by using the mounting tab. Order Model
|
| White | |
|
| Black | |
|
| Red | |
OPERATOR |
|
| |
TERMINAL |
|
| |
STRIP |
|
| |
|
| TO WALL | |
1 | White | PUSH BUTTON | |
SWITCH | |||
| |||
2 | Black |
| |
|
| ||
3 | Red |
| |
| Figure 2 | ||
|
|
Slip on connectors at one end of the adapter connect to the flat side of each spade lug on the receiver, and spade connectors at the other end connect to the operator terminal. Connect the wires as follows:
(a)White wire to terminal “1” or “24v”
(b)Black wire to terminal “2” or “Relay”
(c)Red wire to terminal “3” or “Common” (“Radio Power”)
(d)Connect push button wires to terminal “1” and “2” (See Figure #2).
Where power for the radio receiver is not available from the operator order a M od el 10 92 - 0 1 po w er t r an s f o r m e r ad ap t or f or c o nn e ction between the operator and the remote receiver.
ACCESSING THE CODE SWITCH
Using a small screwdriver, pry the rectangular hatch from the receiver for access to the code switch. On the transmitter the entire front lower half of the case is removable. Grasp the front lower half of the case near the bottom on both sides and pull upward away from the transmitter, this will disengage the lower end. Then pull down ward to remove the lower cover, this will expose both the code switch and battery compartment. Set both switches to the code of your choice, being sure both are set the same since a different setting of just one switch will prevent operation. The digital code is determined by the position of 1 0 s m al l s w it c h es n um be r e d 1 t h rou gh 10 loc ated in the receiver and transmitter. Any combination of “on” or “off” positions can be selected by using a pencil or ball point pen. (Note: The switches are in the “on” position when the switch is depressed toward the number.) See Figure #3.
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
Figure 3
OPEN
Once the codes have been set, check operation and reinsert the hatches.
TRANSMITTER INSTALLATION
The transmitter is completely self contained, including battery, and can be operated while mounted in the car. It is supplied with a clip for attaching to the sun visor, if desired. If the clip is used attach to the case by sliding it into the recess provided on the back of the transmitter until the small dimples fit into the holes in the clip.
CAUTION: Keep the clip flat when pushing it into position so that is doesn’t extend down into the case where it could touch the circuit board and cause damage.
