DXS-32

BY

MINIATURE

SUPERVISED

DOOR/WINDOW

TRANSMITTER

Installation Instructions
(760) 438-7000 • FAX (760) 438-7043
USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340
www.linearcorp.com
DXS-32 FEATURES & ACCESSORIES

MAGNET

ALIGNMENT

PRODUCT DESCRIPTION

The DXS-32 is a battery powered stationary transmitter designed for use with Linear’s DXS and DX format receivers. This transmitter can be used in a variety of wireless remote control applications. Triggering the transmitter with its built-in magnetic switch sends a digitally coded wireless signal to its companion receiver.

The digital DXS code format features over a million possible codes. The DXS transmitters are precoded at the factory to unique codes, so no field coding is required. The DXS-32 can send four different codes: alarm, restore, low battery and status.

Receivers must be programmed to the transmitter’s code before system testing and operation. Refer to the receiver’s instructions for details on programming.

In a typical installation, the magnet is mounted on a door or window and the transmitter is mounted on the frame. When the magnet moves more than 1/2" away from the transmitter, an alarm signal is sent. When the magnet returns next to the unit, a restore signal is sent. The magnet is adjustable with four height positions. A 1/4" high magnet spacer is also supplied to snap on to the base of the magnet.

The transmitter is powered from two 3-Volt #2032 lithium batteries with an expected battery life of up to 4 years. Every hour, the DXS-32 will send a status transmission to the receiver. The hourly signal updates the receiver to the transmitter’s condition. By monitoring status transmissions, the receiver can determine if a transmitter has a low battery or has been removed from the system.DXS format receivers can monitor status signals, DX format receivers cannot.

Normally, the transmitter sends an exit/entry delay transmission code. Cutting an internal jumper selects an instant transmission code. Cutting this jumper doesn’t change the time of the actual transmissions, but changes the code of the signal sent so the receiver can determine the transmitter’s function.

OPENING CASE

REMOVE THE CASE TOP BY TWISTING A

TRANSMITTER

MARKS

MAGNET

SIDE

MARK

SMALL FLAT BLADE SCREWDRIVER IN

THE SLOT ON EITHER END OF THE TRANSMITTER

 

MAGNET

 

ALIGNMENT

TRANSMITTER

MARKS

SCREWS AND

 

DOUBLE STICK TAPE

 

 

MAGNET CAN BE MOUNTED UP TO

 

1/2" FROM LEFT SIDE OF

 

TRANSMITTER

ADJUSTABLE

 

MAGNET

MAGNET

 

 

ADJUSTMENT

 

TAB (EACH SIDE)

MAGNET

 

SCREWS AND

SQUEEZE MAGNET TABS TO

DOUBLE STICK TAPE

ADJUST MAGNET HEIGHT (4 POSITIONS)

REMOVE BATTERY PROTECTION STRIP

PULL OUT & DISCARD

BATTERY PROTECTION

STRIP TO ACTIVATE

TRANSMITTER

TWIST

COMPONENT LOCATIONS

ANTENNA

TWO TYPE 2032 BATTERIES

DELAY/INSTANT JUMPER (CUT JUMPER FOR INSTANT)