EXAMPLE INSTALLATIONS

SLIDING WINDOW

LEFT OPENING DOOR

MAGNET MOUNTED

TRANSMITTERON WINDOW FRAME

MOUNTED ON

DOOR JAMB

(NOTE: SMALL END

 

OF TRANSMITTER UP)

TRANSMITTER

MAGNET

MOUNTED ON

MOUNTED

WINDOW SILL

ON DOOR

 

DOUBLE-HUNG WINDOW

RIGHT OPENING DOOR

TRANSMITTER

TRANSMITTER

MOUNTED ON

MOUNTED ON

WINDOW FRAME

DOOR JAMB

 

 

MAGNET

(NOTE: SMALL END

MOUNTED

OF TRANSMITTER DOWN)

ON WINDOW

MAGNET MOUNTED

SASH STILE

 

ON DOOR

 

ADJUSTING MAGNET HEIGHT

TRANSMITTER MOUNTING

ATTACH BOTTOM CASE

USING THE SCREWS OR

DOUBLE-STICK TAPE PROVIDED

NOTE: ATTACHING THE TRANSMITTER WITH DOUBLE-STICK

TAPE IS NOT ALLOWED IN UL INSTALLATIONS

PROGRAMMING RECEIVER

PROGRAMMING:

ADJUST MAGNET HEIGHT UNTIL CASE LEVELS ARE ABOUT EQUAL

MAGNET

TRANSMITTER

THE SNAP-ON MAGNET SPACER CAN BE USED TO ADD 1/4" HEIGHT TO THE MAGNET (SPACERS CAN ALSO

BE SNAPPED TOGETHER FOR MORE LIFT)

1. PLACE RECEIVER INTO PROGRAM OR "LEARNING" MODE

2. ACTIVATE TRANSMITTER BY OPENING DOOR OR WINDOW

3. VERIFY THAT THE RECEIVER ACCEPTED THE SIGNAL

 

TESTING:

 

1. PLACE RECEIVER INTO TEST MODE

 

2. OPEN DOOR, VERIFY THAT THE

 

RECEIVER INDICATES AN OPEN DOOR

OPEN

3. CLOSE DOOR, VERIFY THAT THE

RECEIVER RECOGNIZED THAT THE

DOOR

DOOR IS CLOSED

CHANGING BATTERIES

LINEAR LIMITED WARRANTY

1

3

SLIDE OLD BATTERIES

OUT OF BATTERY

HOLDERS

INSERT TWO DURACELL DL2032 BATTERIES PLUS (+) SIDE UP INTO BATTERY HOLDERS

2DISCARD OLD BATTERIES PROPERLY

4SEAT BATTERIES COMPLETELY INTO HOLDERS

BE SURE BATTERIES ARE NOT TOUCHING EACH OTHER

This Linear product is warranted against defects in material and workmanship for twelve (12) months. The Warranty Expiration Date is labeled on the product. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any.

There are no obligations or liabilities on the part of Linear corporation for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. All implied warranties, including implied warranties for merchantability and implied warranties for fitness, are valid only until Warranty Expiration Date as labeled on the product. This Linear Corporation Warranty is in lieu of all other warranties express or implied. All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.

FCC NOTE:

This device complies with FCC Part 15 and IC Canada Rules and Regulations. Operation is subject the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT !!!

Linear radio controls provide a reliable communications link and fill an important need in portable wireless signalling. However, there are some limitations which must be observed.

For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15 devices. As such, they have limited transmitter power and therefore limited range.

A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies, regardless of code settings.

Changes or modifications to the device may void FCC compliance.

Infrequently used radio links should be tested regularly to protect against undetected interference or fault.

A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users.

Copyright © 2000 Linear Corporation

216314 B