Linear DXS-80 specifications Wireless Carbon Monoxide Alarm, Specifications

DXS-80

Wireless Carbon Monoxide

Alarm

The DXS-80 is a UL listed†, single station, carbon monoxide alarm with a built-in supervised transmitter. It is compatible with Linear’s wireless DXS Format Security Systems, Personal Emergency Reporting Systems (PERS), and other stand-alone receivers. The DXS-80 provides a warning to alert against both the acute and chronic effects of carbon monoxide (CO) poisoning.

When carbon monoxide is detected, the alarm sounds a loud local alarm. The built-in transmitter sends a digitally coded wireless signal to its companion receiver every 20 seconds until the air has cleared and the detector is restored.

The local alarm can be silenced once by pressing the test/ reset button. The transmitter will continue to send an alarm signal every 20 seconds. After 7 minutes, the alarm will sound again if there is still an unsafe carbon monoxide concentration level. The reset function can be used only once for each alarm occurrence.

No field coding is required because the DXS-80 is factory set to a unique code; one of over a million possible codes.

The DXS-80 is powered by one 3-volt lithium battery.The battery is supplied and can power the unit for up to the six year life of the detector. If the battery voltage drops below a preset level the alarm will sound a low battery chirp every 45 seconds and a low battery signal will be sent to the receiver.

At about 6 years,the carbon monoxide detector element will reach the end of its serviceable life.The self-supervising detector will signal a permanent trouble condition, indicating time for replacement.

SPECIFICATIONS

REGULATORY LISTINGS:		UL2034
	DETECTION METHODS:	Electrochemical
	TIME TO ALARM PER UL 2034:
	Carbon Monoxide	Minimum Time	Maximum Time
	Concentration Level	to Alarm	to Alarm
	50 ppm +/-5 ppm	30 days	Indefinite
	70 ppm +/-5 ppm	60 min	240 min
	150 ppm +/-5 ppm	10 min	50 min
	400 ppm +/-5 ppm	4 min	15 min
	AUDIBLE OUTPUT:	85 dBA/10'
OPERATING TEMP. RANGE:		32º-100º F
	POWER:	3-Volt battery (Lithium Type 123A)
		(UL tested for greater than 1 year service life)
	CURRENT:	7 mA alarm average, 15 µA standby
	FREQUENCY:	315 MHz
	NUMBER OF CODES:	One of 1,048,576 possible codes
	DIMENSIONS:	5.3" diameter, 2.0"h

Model DXS-80

(SST00116)

Carbon Monoxide Alarm

Also available as a kit:

DX-COKIT

(SSA00020)

Kit contains one DXR-702 receiver with a DXS-80 already learned into the receiver

NOTE: The DX-COKIT is not for use

in UL Listed applications

Model DXR-702

(SNR00149)

2-Channel Receiver

COMPATIBLE RECEIVERS†: PERS-3600	PERS-2400A
DXSR-1504	DXSR-1508
DVS-1200	DXR-702
DUAL-824	DVS-2400

†The DXS-80 is currently UL Listed for use with the Linear PERS Consoles only. It has not been tested by UL with other compatible Linear receivers.