Linear WO15Z-1 manual Warranty, Configuration, FCC Notice

ADVANCED OPERATION

Configuration

The WO15Z-1 supports the Configuration Command.

The WO15Z-1 has some features that can be confi gured (if your controller supports it).

The WO15Z-1 can be confi gured to operate slightly differently than how it works when you fi rst install it. You can use a Z-Wave Wireless Controller to send Confi guration commands (refer to the Setup Menu, Confi guration section of the IR-100 instructions). Using the Confi guration command you can confi gure the following:

Set this parameter to 0 to have the blue indicator LED show state of controlled outlet (indicator ON = outlet ON).

Set this parameter to 1 to have indicator show the opposite state of controlled outlet (indicator ON = outlet OFF).

•Configuration Parameter No 3.

•Length: 1 Byte

•Valid Values: 0 or 1 (Default:0)

SPECIFICATIONS

Power	120VAC, 60 Hz
Maximum	Load Resistive: 15 amps (1800 watts) maximum,
	120 VAC
Signal	(Frequency)908.42 MHz
Range	Up to 100 feet line of sight between the Wireless
	Controller and/or the closest HomePro Module

REGULATORY INFORMATION

The WO15Z-1 is certifi ed to comply with applicable FCC and IC rules and regulations governing RF and EMI emissions.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

FCC Notice

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

•Consult the dealer or an experienced radio/TV technician to help.

•Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

IC NOTICE

This Class B digital apparatus complies with Canadian ICES-003

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

Cet appareil numérique de la classe B est conforme à la norme NMB- 003 du Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

WARRANTY

This Linear product is warranted against defects in material and workmanship for twelve (12) months. This warranty extends only to wholesale customers who buy direct from Linear or through Linear’s normal distribution channels. Linear does not warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer’s warranty, if any. There are no obligations or liabilities on the part of Linear Corporation for consequential damages arising out of or in connection with use or performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or reinstallation. All implied warranties, including implied warranties for merchantability and implied warranties for fi tness, are valid only until Warranty Expiration Date as labeled on the product. This Linear LLC

Warranty is in lieu of all other warranties express or implied. All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.

IMPORTANT !!!

Linear radio controls provide a reliable communications link and fi ll an important need in portable wireless signaling. However, there are some limitations which must be observed.

•For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15 devices. As such, they have limited transmitter power and therefore limited range.

•A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals that occur on or near their operating frequencies, regardless of code settings.

•Changes or modifications to the device may void FCC compliance.

•Infrequently used radio links should be tested regularly to protect against undetected interference or fault.

•A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or dealer, and these facts should be communicated to the ultimate users.

Copyright © 2013 Linear LLC P1773 X2

2