Chapter 6: Driver Installation forWindows XP
After connecting the Adapter to
your PC, as shown in Chapter 5,
you’ll need to install the driver.
1. Windows XP will automati-
cally detect the Adapter.
Insert the Setup CD-ROM
into the CD-ROM drive.
Click the radio button next to
Install the software auto-
matically (Recommended)
(as shown in Figure 6-1).
Then click the Next button.
2. A screen similar to that shown in
Figure 6-2 will appear, asking if
you wish to discontinue installa-
tion. This software has been test-
ed and found to work properly
with Windows XP. Click the
Continue Anyway button to
continue installation.
3. The next screen shows that the
Wizard is complete. Click the
Finish button. The drivers are
now installed.
1110
4. When Windows 2000 begins installing the Network Adapter’s driver file, a
screen similar to that shown in Figure 5-3 will appear, stating that a digital
signature was not found. This software has been tested and found to work
properly with Windows 2000. Click the Yes button to continue installation.
If your PC is running Windows XP,proceed to “Chapter 6: Driver
Installation for Windows XP.”
If your PC is running Windows 2000,the installation of the Wireless-B
USB Network Adapter is complete.If you want to check the link informa-
tion,search for available wireless networks, or make additional configu-
ration changes,proceed to “Chapter 7: Using the WLAN Monitor.”
Figure 5-3
Figure 6-2
Figure 6-1
Figure 6-3