Linn 104, 106, 110 C onnecting

In the case of the KOMPONENT 110 and KOMPONENT 104 (where stand is

fitted), the cable(s) can be routed through a duct inside the stand to provide an

invisible connection if so desired. See stand fitting instructions, supplied with

the stands.

Note:

Fit the stand before passing the cable through the duct.

A number of additional configuration options are available, as listed below,

which will enhance the performance of your KOMPONENT loudspeakers. For full

details, see the

manual, which can be found on the Linn

website at www.linn.co.uk. Alternatively, contact your Linn retailer or the Linn

Helpline (Helpline details are listed at the back of this manual).

PPaassssiivvee mmuullttii--wwiirriinngg ((bbii--wwiirree,, ttrrii--wwiirree oorr qquuaadd--wwiirree))

A single amplifier channel connects to a loudspeaker using two, three or four

cables (note – quad-wiring is not available for KOMPONENT 104).

PPaassssiivvee mmuullttii--aammppiinngg ((bbii--aammpp,, ttrrii--aammpp oorr qquuaadd--aammpp))

Two, three or four amplifier channels connect to a loudspeaker (note – quad-

amping is not available for KOMPONENT 104).

AAKKTTIIVV ooppeerraattiioonn

The term ‘AKTIV’ refers to the proprietary Linn active crossovers and

loudspeaker configuration, whereby the loudspeaker’s internal passive

crossover is effectively replaced with external AKTIV crossovers.

This exerts a much greater degree of control over the processing of the audio

signal, providing a more precise audio output to the drive units and therefore

resulting in significantly improved sonic performance, compared with passive

operation.

Important note:

AKTIV operation requires a modification to your loudspeakers and in some

cases, your amplifiers, which must be carried out by an authorised Linn Retailer.

KOMPONENT 110, 106 & 104

Owner’s Manual

Connecting English

ENG KOMPONENT 110_106_104 12/17/04 8:11 AM Page 7