INSTALLATION
vCarefully remove all packing from box.
v Put all the oil from the phial supplied into the bearing housing - NOTE Remove
vCarefully put the Inner Platter into the bearing housing supporting it as it sinks down to prevent damage to the bearing surfaces.
vFit the Belt around the inner platter and motor pulley (see “Speed Selection"). NOTE – BE CAREFUL NOT TO GET OIL ON THE BELT
vFit the Outer Pllatter and Mat onto the inner platter.
If your deck is fitted with a Linn AKITO tonearm, set the Tracking Weight as follows:-
NOTE – the cartridge should be fitted to the arm prior to this procedure – remove the arm from the turntable when fitting the cartridge to the arm to prevent damaging the tonearm bearing during fitting.
vMake sure the arm is clipped into its rest, the bias is off and the lift/lower device is lowered. With tracking dial facing backward, screw the counterweight clockwise (as you look at the dial) onto the arm, pushing gently to engage the thread. Remove the stylus guard. Holding the fingerlift, unclip the arm and move it to between its rest and the platter.
