Mounting to a Mast or Conduit
The antenna may be mounted to a mast, pole or section of vertical conduit. A mast made of
The Mounting Plate is not required, but will provide a stronger mount for the antenna. Secure two commercially available conduit clamps (not included in this kit) to the mast, then attach the Mounting Plate to the clamps and connect the Mounting Bracket to the Mounting Plate, as shown in the photo at right.
If mounted high above receivers, this should be the ground side
www.ListenTech.com
R
Installation of a dipole antenna on a vertical mast with the Mounting Plate. Note that the antenna is installed at the TOP of the mast.
If mounted low, this should be the ground side
Diagram F. Mast Mount without
the Mounting Plate.
IMPORTANT (see Diagram F at left): When installing an antenna on a metal mast, make sure the mast does not extend above the antenna module. If you are mounting the antenna in a high location (such as a stadium), the active element should be at the bottom. If mounted low, the active element will be at the top of the installation. Make sure the antenna is mounted in such a way that the mast will not interfere with the signal.
LISTEN TECHNOLOGIES CORPORATION 8535 South 700 West, Suite A Sandy, Utah
9
