LT-700 Setup Instructions
1Remove the product
Remove outer packaging and plastic cover. Inspect for physical damage. If damage is apparent, please contact Listen Technologies Corporation technical support for assistance. See page 19 for contact information.
2
3
Open the front access door
If locked, use a pocketknife or small screwdriver to unlock the door locks on both sides of the unit. To unlock the door, rotate the lock 1/4 turn counterclockwise.
Grip the two tabs with your thumb and index finger and pull the door downward. Do NOT place batteries in the unit yet.
Select Battery Type |
|
| |
See diagram below. You have two choices: NiMH and Alkaline. The unit is | Unlocked | Locked | |
shipped with the switch in the Alkaline position. Use a pen or small screwdriver | |||
|
| ||
to select the battery type. |
|
|
CAUTION: If you are using any battery type other than rechargeable Nickel Metal Hydride (NiMH) batteries, make sure the BATTERY selection switch is in the alkaline position.
WARNING: Do not place the BATTERY switch in the NiMH position if you are not using Nickel Metal Hydride Batteries. The NiMH position will attempt to charge any batteries in the unit, even if they are not the proper type. Charging
4
5
Set SQ switch
The SQ switch is inside the battery compartment next to the Battery Select switch. The unit is shipped with SQ in the ON position. To turn it off, use a small screwdriver or pen to slide the switch to the OFF position (to the right). See page 14 for more information on SQ.
Set Mic Sensitivity Switch
The microphone sensitivity switch is located inside the battery compartment, to the left of the BATTERY selection switch. The
Mic Sensitivity Switch
Battery Select |
|
Switch | SQ Switch |
|
Part # | Description | Setting |
Lavalier Microphone | MED | |
MED | ||
Noise Canceling Microphone | MED | |
MED | ||
Handheld Microphone | HI | |
Collar Microphone | HI | |
Conference Microphone | MED | |
MED | ||
Lo | ||
| Style |
|
NOTE: If the setting is too low for the microphone the audio will be faint. If the setting is too high for the microphone in use the audio will be distorted.
7