Listen Technologies LT-700-150 manual LT-700Setup Instructions cont, Mono-White, Stereo-Red

LT-700 Setup Instructions (cont.)

6Place Batteries in Unit

Place two (2) AA batteries in the compartment, making note of the battery polarity shown in the battery compartment, and again verifying that the BATTERY SELECT switch is in the correct position for the batteries you are using. (ALK should be selected for all battery types other than NiMH).

NOTE: Listen uses 2300mAh (milli-Amp-hour) constant current NiMH (Nickel Metal Hydride) batteries. These may be purchased from your Listen dealer (ask for part number LA-362).

7Connect the Microphone

The microphone jack is located on top of the unit. The LT-700 uses the microphone cable as an antenna for transmitting.

8Optional - Connect the Line Input Cable.

This cable allows you to connect a TV, CD player or other equipment to the LT-700. To do this, you must order the Listen LA-263 Line Input Cable (it is not included with your unit). This cable allows you to connect both a microphone and line input to the jack on top of the LT-700. See the diagram below for connection information. You can use the microphone and the line input at the same time. Please note that the MUTE switch mutes only the microphone; the line source will continue transmitting when the switch is in the MUTE position.

If you prefer to make your own cable for connection of mic and line inputs, connection shown in the following diagram:

Mono-White	Video-Yellow
Stereo-Red

LA-263

1

mm

8