Listen Technologies LT-800-072 LT-800Setup Instructions, 1Unpack the Product, 3Connect Antenna

LT-800 Setup Instructions

1Unpack the Product

Remove outer packaging and plastic cover. Inspect for physical damage.

2Mount in Rack (if necessary)

If rack mounting the unit, install the optional rack mount kit (part LA-326) according to the

instructions included with the kit, then install the LT-800 in the rack.

NOTE: If rack mounting, you will need to use a rear connection antenna.

Rack Mount with dual unit installed	Rack Mount with single unit installed
	Shown with LT-800

3Connect Antenna

Connect the antenna (not included) according to the installation instructions. Only use an antenna supplied by Listen. If you are connecting the antenna directly to the top of the LT-800, you will need to remove the rubber plug on top of the unit. If you are using a remote antenna connected to the rear of the unit, do not connect an antenna to the top connector. See page 22 for antenna options, or refer to the Listen website for remote antenna options, www.listentech.com.

	Coax antenna connection.
	Rear of LT-800 shown.
LA-122 Remote Antenna
See RF Reception Maximization
Strategies and Coaxial Cable on	rubber plug
page 13.
	LT-800 shown with top mount
	antenna connected through top of
	unit (part numbers LA-101, LA-106 (72
	MHz) or LA-102 (216 MHz)

4Connect Power

Plug the power supply into the power connector on the back panel, then plug the power supply into an outlet. Only use a Listen approved power supply (The LA-207, an in-line switching power supply, is the approved power supply for this unit).

12 VDC 1.3 A

5Select Phonak Compatibility (if necessary)

If you will be using Phonak receivers with your LT-800 (216 MHz only), the transmitter can become completely compatible through software control. When switched to this mode, the LT-800 transmitter will display the Phonak channels. By integrating Phonak channels and compatibility into the LT-800-216, it is more convenient to use Phonak receivers with Listen transmitters. (www.phonak.com)

Setup Instructions

7