Little Wonder 8221, 8271 manual H. Attaching the Hose Band to the Chain Loop Assembly Figure #6

G. Attaching the Chain Loop Assembly to the Boom Arm Assembly (Figure #6)

1.Slip the threaded end of the Chain Loop Assembly (720290) through the hole found at the end of the Boom Arm Assembly (720285.17).

2.Once through, secure the Chain Loop Assembly with the Nut (64229-05).

3.The level position of the Hose Assembly to the Inlet Flange Assembly can be controlled by adjusting the position of the Nut on the thread of the Chain Loop Assembly.

NUT (720576)

BOOM ARM

ASSEMBLY

CHAIN LOOP

ASSEMBLY

NUT (720585) BOLT (720588)

HOSE

BAND

H. Attaching the Hose Band to the Chain Loop Assembly (Figure #6)

1.After wrapping the Hose Band around the Hose, insert the Bolt (64123-61) through the holes in the Hose Band.

2.Once through, secure the Bolt in the Hose Band with the Nut (64229-02).

3.Attach the Hose Band to the Chain Loop Assembly by connecting the chain to the Bolt (64123-61) via the supplied Carabiner Quick Clip (720487)

4.Make sure the Hose Band is in the proper position with respect to the Hose to allow free movement with the Boom Arm Assembly.

I.Adding Oil to the Engine

1.Fill the crankcase with the proper oil to the “F” mark found on the dipstick. The oil recommendations are found in the Engine Oil and Fuel section of this manual.

J.Filling the Gas Tank

1.Fill the tank with the proper fuel. Take extra caution when filling the tank not to over-fill it. The fuel recommendations are found in the Engine Oil and Fuel section of this manual.

Figure #6

FIGURE #6

K.Connecting the Battery

1.Connect the Red Battery Cable (720339) found connected to the engine starter to the positive terminal of the battery with the Bolt (64123-114) and Nut (64268-01) provided.

2.Connect the Black Battery Cable (720340) found connected to the engine block to the negative terminal of the battery with the Bolt (64123-114) and Nut (64268-01) provided.

8