Little Wonder Tiller/Cultivator owner manual Assembly, Warning • Danger, 8,7,42

ASSEMBLY

!!

WARNING • DANGER

IMPROPER ASSEMBLY OF THIS TILLER CAN RESULT IN SERIOUS INJURY.

26 27 8,7,42

MAKE SURE TO FOLLOW ALL INSTRUCTIONS CAREFULLY.

IF YOU HAVE ANY QUESTIONS CONTACT OUR FACTORY AT 1-800-366-6268

5

1

2

OR AN AUTHORIZED

MANTIS DEALER

Your MANTIS Tiller comes partially assembled. You must install only the handlebars, the carrying handle, and the tines. This will take just a few minutes if you follow the directions.

First, take all items out of the carton. But do not remove the cardboard from around the Tiller’s base.

The list at the right, shows the parts that come with your tiller. Check to make sure you have them.

The bag of hardware is in the plastic bag containing the Owner’s Manual.

To assemble your MANTIS Tiller, you’ll need two 7/16” wrenches or two adjustable wrenches. We suggest that you install all nuts and bolts only “finger tight” — that is, one-half to one full turn — until you’ve completed assembly. The nuts are self locking, but you must use a wrench to tighten them completely.

3

	29	39
	40
Quantity	Description	*Key #
1	Upper Handle Assembly	2
1	Upper Handle Throttle Side Assembly	1
2	Lower Handles	3
1	Pair Tiller/Cultivator Tines	26/27
1	Engine Assembly (includes Fender
	Guard & Worm Gear Transmission)	8, 7, 42
1	Handle Brace	5
1	Plastic Carrying Handle	29
1	Bag of Hardware Containing:
2	Cap Screws	34*
4	Lock Nuts	35
2	Bolts (3” long)	36
2	Tine Retaining Pins	28
2	Handle Clamps	38
1	Throttle Clips	6
2	Bolts	39
2	Knobs	40

*These numbers are the same numbers shown on the Parts Layout on page 27.

6