ASSEMBLY (continued)
HOW TO ASSEMBLE UPPER HANDLES & PLASTIC CARRYING HANDLE.
1.Lightly squeeze the lower handles (#3) toward one another so that they line up with the two smaller holes on the carrying handle (#29). Then slide the carrying handle over and down the lower handles. It will rest about four to six inches above the engine. (Picture 1)
2.Gently pull the lower handles out to their original position.
3.Attach the upper handle assembly (#1) – the handle with the throttle cable and ground wire – with the handle knob (#40) and 1 round head bolt
(#39) (Picture #2). Be sure you have proper throttle movements and that the throttle cable is not wrapped or twisted around the handle bar. Squeeze trigger and let go. The triangle must click in both directions. If there is any doubt, remove air filter and visually check that the throttle triangle hits both the idle screw and the full open stop. THIS MUST BE DONE BEFORE STARTING THE ENGINE.
4.Follow the same steps to install the other upper handle onto the other lower handle.
(Picture 3)
5.Use the clip (#6) to secure the throttle cable and wire in place on the lower handle. (Picture 4)
6.Now install the Handle Brace. Line it up with the holes on the upper handles. Then insert a Cap Screw (#34) and a Lock Nut (#35) on either side (Picture 5)
7.Use a wrench to tighten Cap Screws and Lock Nuts.
8.Now use wrench to tighten all nuts and bolts firmly and securely.
IMPORTANT NOTE:
Make sure you have installed the handles properly. When you stand behind your tiller, holding the handles, you should face the gasoline tank.
Picture 1
!WARNING: Improper throttle installation can cause tines to rotate unexpectedly .
! WARNING • DANGER !
REMOVE TINES BEFORE STARTING ENGINE
AND MAKING ADJUSTMENTS.
Picture 2 | Picture 3 | Picture 4 | Picture 5 |
8
