User’s Information Manual
3SMART SYSTEM control module
Power-fin control module
Use the control panel (FIG.
Figure 3-1_ Control Panel
Access modes
User
The user can adjust the space heating target temperature and the tank target temperature (if a tank sensor is used) by using the UP and DOWN buttons (FIG.
•Boiler outlet water target temperature in DHW Mode
•Appliance model number
•Software version
•Total operating hours
•Total cycles
Installer
Most parameters are available only to the installer, accessible only by entering the installer access code, see the
Saving parameters (reference the Parameter Table in the
To save parameters and exit programming:
Press the ENTER/RESET button, then the MENU/EXIT button 3 times.
To keep parameter settings only for a current operating cycle:
Press the MENU/EXIT button 3 times after making all desired parameter changes.
To enter a parameter and continue programming:
Press the MENU/EXIT button 1 time to return to the parameter listings; press again to return to the menu listings. Remember to press the ENTER/RESET button when finished programming in order to save the changes made.
See the
9