First installation

If the reception conditions are good, then a room antenna may be used for DVB-T. Passive and active room antennas are available on the market. The power is sup- plied for an active antenna via the antenna connection. For automatic programming or in “TV Menu – Connections – Antenna DVB – Antenna DVB-T,“ the distribution voltage (5 volts) is to be set correspondingly.

It may be practical to use a nondirectional antenna. If the location is outside the normal transmitting range, then a unidirectional antenna may also be used to improve the reception quality.

You can find out more on the digital stations that can be received in your area at your specialist dealer.

If a set was retrofitted with a PIP tuner or if this is already integrated in a set with a digital recorder, then plug the antenna into the antenna input of the PIP tuner and connect the PIP tuner output with the ANT-TV socket (Tuner 1). See illustrations on page 6/7.

Set-specific equipment and retrofitting options for PIP and satellite tuners, see pages 44 and 45.

Using the conditional access module

In order to be able to receive encrypted digital stations, a Conditional Access module (CA-module (1) and a Smart Card (1, if necessary, must be inserted into the corresponding slot of your TV set. You can find the Common Interface slot (CI-Slot) on the back of your TV set, see the illustration on pages 5 –7.

1. Make sure the TV set is switched off with the mains switch on the set.

2. First push the smart card into the CA module as far as it will go. Insert it so

that the side with the

 

 

 

 

 

 

 

 

 

 

golden contact chip faces

 

side

 

 

 

the side of the module

 

 

 

 

 

Contact

 

 

 

printed with the supplier‘s

 

 

 

 

brand logo. Printed arrows

 

 

 

 

 

 

 

 

 

indicate how to insert the

 

 

 

 

 

card. Also follow the instal-

 

 

 

 

lation instructions included

 

 

 

 

 

 

 

 

with the smart card.

 

 

 

 

If a Digital Satellite Tuner 1 has been retrofitted, connect your satellite antenna system to the ANT-SAT socket.

If a Digital Satellite Tuner 2 has been retrofitted, connect one antenna cable each, for example from the antenna switch or from the twin LNC, to both SAT sockets.

When laying the cable, use the cable clips affixed beneath the TV set. Replace the connection cover on the TV set.

Use of the binders for Xelos A42 and Modus L 42

3.Slide the CA module (1 carefully into the slot with the contact side facing the front. When you are standing in front of the TV set, the logo on the CA module must face the rear.

Make sure the module is not twisted in the process. Do not use force.

When the module locks, the eject button is pressed outwards.

(1 The CA module and the smart card are not included in the scope of delivery for this set; you can usually obtain them at your specialist dealer.

Eject button

CA module

CISlot-

The enclosed binders are intended for holding the connection cables together and fastening them to the rear panel.

The binders can be opened again by pressing on the binder latch.

Switching on

Press the mains switch. The indicator lamp on the set now turns red (standby mode).

Switch on the set using the switch integrated in the indicator. The indicator on the TV set lights up and turns green (indicator lamp).

- 12

Page 12
Image 12
Loewe L 37, L 42, L 32, A 42 Using the conditional access module, Use of the binders for Xelos A42 and Modus L, Switching on