Logitech® Bedside Dock
3 Set the clock and alarm
The clock and alarm receive power from the AC power supply. When power is interrupted, the clock and alarm continue to run on the two AAA alkaline batteries.
The alarm has two separate settings and a choice of alarm source. Wake up to sound from a docked device, FM radio, or alarm beep.
Time set: Press the Time Set button to set the time. The hour digits flash on the display. Use the Tune + or Tune – buttons to specify the hour. Press the Time Set button again. The minute digits flash. Use the Tune + or Tune – buttons to enter the minutes. Press the Time Set button once more to save your entry. Follow this procedure anytime you need to reset the time.
Alarm set: Press and hold the Alarm button to set alarm 1. The alarm 1 icon appears on the display and the hour digits flash. Release the button. Use the Tune + or Tune – buttons to specify the hour. Press the Alarm button again. The minute digits flash. Use the Tune + or Tune – buttons to enter the minutes. Press the Alarm button again. The alarm source flashes. Use the Tune + or Tune – buttons to choose an alarm source (e.g., docked device, radio, or buzzer). Press the Alarm button once more to save your entry. To set alarm 2, press the Alarm button until the alarm 2 icon appears. Repeat the procedure for setting alarm 1.
Note: If a docked device is disconnected from the Bedside Dock and this device has been selected as the alarm source, the Bedside Dock uses the alarm beep as the alarm source.
Alarm activation cycle: After you have set alarms 1 and 2, pressing the Alarm button repeatedly cycles through the following alarm activation states:
6 English
