Lopi Clean Face Gas Fireplace dimensions Features Constitutiontm, Gas Input & Performance

Features: Constitutiontm

Clean Face Gas Fireplace

• No grills for a traditional masonry fireplace look.

• Durable, tempered glass with safety screen.

Screen is removable.

• Fire viewing area 1080 sq. in.

• Realistic, four-piece detailed log set with embers and twigs.

• Digital Home Comfort Control System can be operated by

the hand-held remote control and the wireless wall control.

GAS INPUT & PERFORMANCE:

•Adjustable High Heat System:

20,800 – 38,000 Btu's (NG)

23,500 – 38,000 Btu's (LP)

•Heater Rated Fireplace: Heats up to 1,000 sq. ft.*

*Heating capacity will vary depending on the temperature zone

• Operate Your Fireplace Green - The Electronic Gas Valve can

be run for greater efficiency in the “Intermittent Pilot Mode”

with the gas pilot turned off until you need it or “Standing

Pilot Mode”,with the gas pilot always on, for reliable cold

weather operation.

• Natural (NG) or Propane (LP) operation.

• Uses Simpson Duravent 8 5/8” x 6” chimney.

• Seven Year “Real World” Warranty.

FRAMING DIMENSIONS:

See Installation Manual or visit www.lopistoves.com under Constitution

1.Hearth Requirements: Extends 10” from face and 49 1/2” wide when installed flush. Not required when raised 6”

(See Installation Manual or www.lopistoves.com for details)

2.Non-combustible facing - Two side and two top pieces provided with fireplace.

7

3. Side Wall Clearance: 11”

4. Mantle Clearances: 50” from base of fireplace. Maximum allowed mantle depth: 12”

5.Minimum fireplace enclosure height 60”. Measured from base of fireplace.

you live in.

5

4

3

4

Maintain

a 14” min. width between studs and max. 3 1/2” depth of studs for chimney clearance.

6

41 1/2”

6.	Minimum framing:	1
	50” wide x 56 3/4” tall x 25” deep.
7.	Facing Requirements:	2
	Provided fiber board or other non-combustible

material must extend from the base of the fireplace to the header and to the framing members on both sides

1

Tested and Certified by OMNI-Test Laboratories Inc. to ANSI Z21.88b “Vented Gas-Fired Direct Fireplace Heater”.

Must be installed in accordance with all local codes, if any:if not, follow ANSI Z223.1 and the requirements listed in the Owner’s Manual.

1
”
	to 1-
	1/2
	”
		Thick	Cement
				Board

. ”Min 10

. ”Min 25

Note: Improper installation of your gas appliance or failure to operate it in accordance to the guidelines detailed in the Owner’s Manual may negate your warranty. We recommend all Lopi appliances be installed and maintained on an annual basis by your specialty hearth retailer.

Your Lopi Authorized Dealer is Located At:

Visit us online at: www.lopifire.com

© Copyright T. I. 10/2007 Printed in U.S.A.

We reserve the right to improve or change our products without prior notification. Consult the Owner’s Manual for complete installation requirements. Photos and illustrations are for descriptive purposes only. #98800000