2. QDR-TELS Installation

Step 1: Connect the QDR-TELS to the I/O Alarm Block of the VistaPro 4

Using the USB Cable supplied, plug one end into the USB port found on the I/O Alarm Block (see diagram) and the other end to the USB port found on the QDR-TELS module.

Step 2: Connect the QDR-TELS to the premises telephone line.

Using the supplied telephone cable, plug the RJ-11 modular plug into the ‘TEL IN’ RJ-11 jack, (located on the back of the QDR-TELS Module). The other end of the telephone cable is then plugged into a premise RJ-11 wall jack.

To connect a local telephone to the QDR-TELS, simply plug the cable from the telephone into the ‘TEL OUT’ RJ-11 Jack on the module.

Step 3: Power Up the Module

To apply power to the module, plug the power connector from the supplied Power Supply Adapter into the Power Jack (located on the back of the QDR-TELS module). Plug the Power Cord into a 110/120 VAC outlet..

NOTE: By default, the system password is 0000 and the rings to answer is set at 3.

Page 3
Image 3
LOREX Technology manual QDR-TELS Installation, Connect the QDR-TELS to the I/O Alarm Block of the VistaPro