76
Hard Drive Replacement - Appendix #8
Hard Drive Replacement - Appendix #8
The System comes with a pre-installed Hard Drive, however the unit will work with a replacement
single Hard Drive (up to 500GB).
NOTE: Make sure that the System is OFF and the power cable has been disconnected before
changing the Hard Drive.

Setting the New Drive to Master

• Refer to the General Jumper Pin Setting on HDD Surface (generally located on a sticker on
the top of the drive).
• Set the Jumper Pin Set to Master (1 Drive).
NOTE: Use a Hard Drive Model with a power supply rated UDMA66 or higher.

Connecting the IDE Cable

• Confirm the IDE Cable is securely connected within the System.
• The IDE Cable has Three Connectors:
zBlue Color Connector: Must be Connected with Main Board.
zOther Connectors: Connect to the HDD