17
h) DEFAULT SET : Selecting [Y] resets all programmed settings back to the default factory
settings (except for the time & date).
NOTE: If you perform a DEFAULT SET, the programmed data you have entered for the
DDNS will be automatically deleted. You need to set the data again.
7.7 SYSTEM SET (II)
This sub-menu allows you to configure various preferences on the system, related to DVR
settings.
a) HDD INFO DISP : Sets the display settings for information on the HDD status. This can
be displayed as a percentage of HDD space used, or amount of Bytes available, or the
HDD information display can be set to OFF.
b) RS232 BAUD RATE : Sets the speed at which the RS 232 input and the computer
communicate. Baud Rate, which is the rate of data transmission, can be set to: OFF,
2400, 4800, 9600, or 19200.
c) PASSWORD SET : If you select [Y], you will need to input a password when you enter
the Main Menu, and [N] will allow you into the menu without a password. Changes your
password for accessing the Menu. The password must be 4 digits.
d) NETWORK (TCP/IP) : There are 3 selections to choose
Dynamic IP: enabling this option will result in the unit automatically obtaining an IP
address from the Router
Static IP: Enabling this option will allow the user to set their IP address
OFF: if this option is enabled, networking will be disabled.
e) USER ID/PASSWORD : User can set password for Master ID and account. Default
value - ADMIN
f) GUEST PASSWORD : User can set password for GUEST account. Default value –
GUEST
NOTE: Master gets full accessibility in network whereas GUEST can view only
g) BAND WIDTH
h) IP ADDR : Set IP address for enabling network.
Default value - 192 168 001 100
NOTE: automatically set when Dynamic IP is enabled
i) SUB NET : User can set Subnet Mask value for enabling network.
Default value - 255 255 255 0
NOTE: automatically set when Dynamic IP is enabled
j) GATEWAY : Setting up Gateway value for enabling network.
Default value - 192 168 001 001
NOTE: automatically set when Dynamic IP is enabled
k) PORT : Setting up Port value for enabling network.
Default value - 5000
7.8 HDD / REC SET
This submenu allows you to set the Record parameters for your Hard Disk Drive.