26
4. Use the UP and DOWN keys to change the Device Name. When you
have finished inputting the desired Device Name, press ENTER. Press
EXIT repeatedly to return to the main display.
To reset device name to default setting:
1. Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight BUS SETUP and press ENTER, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the pressure sensor with the device name you want to reset
and press ENTER. The Device Configuration menu will appear with the
Device Name dialog box highlighted.
4. Press ENTER. Depress the left arrow key until the device name
disappears. Press ENTER, then press EXIT to return to the NMEA 2000
menu.
5. Highlight the device and press ENTER. The Device Configuration
menu will open. The device name will be reset to its default setting.
Press EXIT repeatedly to return to the main display.
To select Location:
1. Press MENU twice, select NMEA 2000 or NETWORKING and press ENTER. A
menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight BUS SETUP and press ENTER, which will open the Bus
Configuration menu. A list of network devices will be at the top of the
page.
3. Select the desired pressure sensor and press ENTER. The Device
Configuration menu will appear.
4. Highlight LOCATION and press ENTER.
5. Select the desired location or the default (Unknown) and press
ENTER. The following message will appear: Are you sure you wish to
change this device's configuration?
6. Select YES and press ENTER. Press EXIT repeatedly to return to the
main display.