LST AD-58000-400 manual Description, Building Safety. Building Security, Thermal Detector

Thermal Detector

AD-58000-400

•ADM loop technology with Apollo/Discovery protocol

•For use as maximum heat or rate-of-rise heat detector

•5 different operating modes selectable

•Optional connection of remote indicator

•Sealed electronics

Description

The addressable Thermal Detector AD-58000-400 is based on the heat principle and was developed for the indoor temperature supervision in a wide range of fi re detection applications.

Depending on the parameter setup in the fi re detection control panel, the detector operates either as maximum heat detector with an alarm temperature of 61°C (EN 54-5 Class A2S) or 90°C (EN 54-5 Class CS), or as rate-of-rise heat detector with a maximum temperature of 58°C (EN 54-5 Class A1R), 61°C (EN 54-5 Class A2) or 90°C (EN 54-5 Class CR). In Class A1R the detector can be used up to a room height of 7.5m, in the other operating modes a room height of 6m is permissible.

The proven ADM loop technology with Apollo/Discovery

protocol establishes a permanent communication bet- ween the fi re detection control panel and the detector. That ensures a periodical function testing of the detec- tor. Fires are safely detected in the control panel by continuously analysing the measured values.

The two LEDs with 360° visibility indicate the activated condition of the detector. The detector address is se- lected by means of a code card in the detector base. Therefore the detector can be changed without additi- onal tools.

The detector can be attached to various bases and it can be protected against theft.

Building Safety. Building Security.

A

© LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL +43 1 52114-0 • FAX +43 1 52114-27	AD-58000-400_DBL_LST_EN_0804.PDF • PAGE 1
OFFICE@LST.AT • WWW.LST.AT • ALL RIGHTS RESERVED