Lucent Technologies 362EC installation instructions Lights

SAVE THESE INSTRUCTIONS

1Remove the clear, plastic protector from the connector on the right side of the new 362EC module by grasping the tabs on the ends of the protector and lifting. If you are upgrading from a stand-alone system, also remove the protector from the wall-mounted PARTNER Endeavor processor module.

2 A) Remove the #8 sheet metal screw from the bottom of the wall-mounted module or modules.

B)If you are upgrading an existing stand-alone system, skip to Step 4B.

3If you are replacing the second module in a two-slot carrier, remove the two #4 screws holding the carrier in place and gently pull the carrier off the modules.

4 A) Slide the second module off the PARTNER Endeavor processor module and put it aside. B) Slide the 362EC module onto the PARTNER Endeavor processor module, making sure the mounting tracks interlock, as shown in the side view.

! CAUTION:

5 Attach the 2-Slot carrier to the top right side 6 of the two modules:

A)Align the carrier carefully and then push firmly until the connectors on the modules snap into the carrier.

B)Fasten the carrier to the modules using the two #4 screws included with the carrier.

Insert the 3 1/2" #8 screw into the bottom of the modules. Tighten it until the mounting tracks of the PARTNER Endeavor processor module are flush against the wall with a 3/8" (1 cm.) gap between the wall and the rest of the PARTNER Endeavor processor module. Do not overtighten, the modules will warp.

Caution: Do not force the module. If the module does not insert easily, remove it, clear any obstruction, and reinsert it.

362EC

Module

MUSIC

ON

HOLD

Combo Combo

7 A) Label the lines and extension jacks.

B) Connect the line and telephone cords to the appropriate jacks on the new module.

C)Route each cord through the hook on the front of its module. D) Connect the free end of each phone cord to the modular wall jacks for system extensions.

Press the power cord firmly into the power	9
8 jack on the carrier. Plug the other end of the

power cord into a properly grounded three-prong wall outlet not controlled by a switch.

Lights

ECS	362EC
Proc.	Module
P F T	4
1
2	5

Check the green lights on the fronts of the modules. If a single light is out, power down the carrier, then power up the carrier. If both lights are out, power down the carrier, reseat both modules, then power up the carrier. If the lights are still out, in the Continental U.S.,

NOTE:

Connect ETR and T/R combination devices to the last two ports on the PARTNER Endeavor processor or 362EC module.

call the hotline at 1-800-721-7071. Outside the Continental U.S., contact your Lucent Technologies Representative or local Authorized Dealer.