Lucent Technologies 6225 manual TABLE/DESK Installation, Wall Installation

—— INSTALLATION ——

TABLE/DESK INSTALLATION

Use the 7-foot straight line cord that came with your telephone to connect the telephone to a modular jack.

! WARNING:

Do not plug the handset cord into the line jack or the data jack on your telephone since it could damage your handset and the telephone.

1.Turn the telephone upside down so that you can see the bottom of the telephone. See Figure 2.

Desktop stand

Line jack

4 holes for wall mounting

Figure 2. The Bottom of the 6200 Series Telephones

2.Remove the desk stand by sliding it to the left until it is free of the telephone base. See Figure 3.

Desktop	Slide stand
stand
	to left and lift

Figure 3. Sliding the Base from the Bottom of the Set

3.Plug one end of the line cord into the line jack on the bottom of the telephone.

4.Align the other end of the line cord so that it appears through the slot at the top of the stand and reattach the stand to the telephone by sliding the stand into the appropriate tabs and to the right.

5.Turn the telephone right-side up and place it on your desk or table.

6.Plug one end of the coiled handset cord into the handset jack on the side of the telephone.

7.Plug the other end of the handset cord into the handset.

8.Hang up the handset.

9.Plug the free end of the line cord into a modular wall jack.

10.Lift the handset and listen for dial tone.

11.Set the Ringer Volume Control switch to the setting you want.

WALL INSTALLATION

Use the following directions to mount the telephone on a standard wallphone jack with mounting studs.

NOTE: For wall installation, do NOT unbundle the line cord packaged with the telephone; that is, leave it in its coiled position.

1.You must reverse the handset tab (which holds the handset when you hang up). See Figure 3.

•Hold down the switchhook and slide the handset tab up and out of its slot.

•Turn the tab so that the curved end is facing up.

•Insert the tab back into its slot.

2.Turn the telephone upside down so that you can see the bottom of the telephone.

a. Handset	b. Press to release
retainer	and then remove
in place	handset retainer

c. Reposition		d. Replace handset
handset	(up	retainer
retainer
	position)
down

(down

position)

Figure 3. Reversing the Handset Hook

3.Remove the mounting base by sliding the base to the left until it is free of the telephone. See Figure 3.

4.Turn the base so the larger end is down.

5.Plug one end of the line cord into the line jack on the bottom of the telephone. (Keep the cord bundle in the cavity on the lower housing.) Leave the other end of the cord unattached for later use.

NOTE: You may prefer to use an 8-inch line cord rather than the 7-foot cord provided with the telephone. If you use the 7-foot cord, you will need to place it into the back of the telephone in its original coiled position.

6.Slide the reversed base onto the telephone, to the right, until it snaps into place.

	Invert stand
		Position	stand
Holes		over 4	holes,
		push stand down,
for wall
		and slide to left
mounting

Figure 4. Installing the Stand for Wall Mounting

7.Plug one end of the coiled handset cord into the handset jack on the side of the telephone.

8.Plug the free end of the line cord into a modular wall jack.