Lucent Technologies P333T quick start Power up, Cajun P330 AC Version, Cajun P330 DC Version

Power up

Cajun P330 AC Version

1.Insert the power cord into the power connector (BUPS or Power Supply) on the rear of the unit.

BUPS connector

AC connector

2.Insert the other end of the power cord into the electricity supply or the BUPS connector.

K The unit powers up and performs a self test procedure. The LEDs flash at regular intervals after the self-test procedure is completed successfully.

3 Cajun P330 DC Version

WARNING: Before performing any of the following procedures, ensure that DC power is OFF.

CAUTION: This product is intended for installation in restricted access areas and is approved for use with 18 AWG copper conductors only. The installation must comply with all applicable codes.

DC terminal block

1.Connect the power cable to the switch at the input terminal block on the rear of the unit.

EThe terminals are marked “+”, “-“ and the IEC 5019a Ground symbol.

EThe size of the three screws in the terminal block is M3.5.

EThe pitch between each screw is 9.5mm.

2.Attach the appropriate lugs at the wire end of the power supply cord.

3.Wire the DC power supply to the terminal block.

KThe unit powers up and performs a self test procedure. The LEDs flash at regular intervals after the self-test procedure is completed successfully.

WARNING: The proper wiring sequence is:

•ground to ground

•positive to positive (line to L)

•negative to negative (neutral to N)

Always connect the ground wire first and disconnect it last.