Lucent Technologies quick start Connect the cables, Connect the console cable, Cajun P333T LEDs

Connect the cables

Connect PCs, servers, routers, workstations, and hubs

1.Connect the Ethernet connection cable (not supplied) to a 10/100 Mbps port on the front panel of the Cajun P330.

EYou should use standard RJ-45 connections. You must use CAT-5 cable for 100 Mbps operation.

2.Connect the other end of the cable to the Ethernet port of the PC, server, router, worksta- tion, switch or hub.

EUse a cross cable when connecting the Cajun P330 to a switch or hub.

3.Check that the appropriate link (LNK) LEDs light up.

Connect the console cable

1.Configure the serial port settings of the PC or terminal as follows: Baud Rate – 9600, Parity – no, Data bits – 8, Stop bits – 1, Flow control – no.

2.Connect the supplied special RJ-45 connector to the port marked “Console” on the front panel of the Cajun P330.

3.Connect the other end of the cable to a terminal or PC with terminal emulation software installed.

Cajun P333T LEDs

Left/Right & Reset Switches

Port LEDs

4

FIV switch Function LEDs

FIV – Force Initial Version (see Cajun P330 User’s Guide)

LNK – When ON, link is OK

COL – When ON, indicates a collision on the port in HDX mode

Tx, Rx – Shows traffic activity for transmitted and received packets FDX – Shows Full/Half Duplex mode

FC – When ON, Flow Control is enabled for a port in FDX mode

Hspd – Shows speed of port (10 Mbps or 100/1000 Mbps)

LAG – When ON, the port is included in a Link Aggregation Group (LAG).

ROUT – Shows switch’s mode of operation SYS – Shows whether this module is the Cajun P330 Stack Master agent

OPR – Shows CPU boot status PWR – Shows when power is on