M&S Systems 8-Ohm owner manual Speaker Installation For Existing Construction

Step 5. Divide each adhesive bead strip in half. (Adhesive bead strips are in the clear self-closing bag). Place strips on the edge of the grill as shown in Figure 2. Reinstall the grill on the speaker.

Step 6. Follow the instructions included with the vol- ume control and amplifier to complete the installation.

Cam-locke mounting tab shown in the install position (4 places)

Connect to 16 Gauge 2

Figure 1 conductor wire from wall plate

l

SPEAKER INSTALLATION FOR EXISTING CONSTRUCTION

For existing construction, use the same guidelines for new construction with the following precautions. It is very important to determine what is behind the wall space that you will open when installing the speakers. Check for standard stud spacing (16” on center pre- ferred) so you will not need to cut studs and check the wiring path to the volume control and amplifier. Avoid 120V wiring and air return duct and pipe. Proper speaker spacing is also critical to a good system.

Page 7