Flake Ice Machines | Drive System |
Seal Face Installation
Lightly lubricate the rubber portion of the seal face and apply a small amount of silicone sealant to the metal part of the seal face (rubber side) that seats against the auger. Install the seal face on the auger. Caution: Do not scratch or damage the seal face.
Torque bolt to 40 ft/lbs.
Pack bearing with grease prior to installation
Evaporator Reassembly
Lubricate the upper
grease. Install the bearing over the bearing journal, install the washer and bolt, tighten to 40 ft/lbs.
Lightly lubricate the
tighten the lower nut setscrews.
Apply silicone sealant to the rubber side of the seal; do not
apply silicone to the flat portion of the seal
Carefully install the seal face, as shown, do not damage the flat portion of the seal
Torque setscrews to 55 inch pounds
Carefully install the auger and upper housing assembly into the evaporator barrel, taking care not to scrape the evaporator walls. Push downward on the housing until the bearing housing is seated against the evaporator barrel. A rubber mallet may be needed to tap the housing into place. Install the grease cap and tighten the upper evaporator nut.
Reverse the first 6 steps in the Evaporator Disassembly Section.
Auger should turn freely by hand
Page E7