UNLOADING DISC MAGAZINE
Unloading the disc magazine is performed by first sliding the access door to the right. Next, press the eject button located below the window on the magazine. Pressing this button will activate the magazine release mechanism. When ejected, the magazine will extend outward 1". You may then pull the disc magazine out completely.
STEP 1 - open magazine door and press the eject button.
Eject button
STEP 2 - Wait for the magazine to extend and stop (approximately 1 inch outward).
STEP 3 - Pull the magazine from the MCD6 player and close the sliding door.
CARE AND MAINTENANCE
No maintenance is required to provide reliable operation. The MCD6 can be cleaned using a slightly dampened cloth. No chemicals should be used to clean the face panel components. Many common household chemicals may damage or discolor the face panel components. Use care when cleaning the display window.
TROUBLESHOOTING TIPS
|
| |
Will not power on | Check for tripped circuit breaker. | |
|
| |
Magazine will not eject | Sliding door not opened fully. | |
|
| |
"Err 07" displays when | Disc is not readable or is installed in the magazine | |
disc is selected for play | upside down. Disc must be installed with the label up. | |
|
| |
"Err 07" displays while | Disc is dirty, damaged, or scratched. | |
disc is playing |
| |
|
| |
Display does not light | Press Track up and Mode at the same time and hold | |
| for 3 seconds to enable. | |
|
| |
"Err 01" displays | Disc is jammed. Try ejecting the magazine. | |
|
| |
| Shipping screws have not been removed upon | |
| installation. | |
|
| |
Display shows disc is | AUX is not selected on the | |
playing but nothing is |
| |
Check to see if FM or AM plays on the radio | ||
heard | ||
| intercom. If not, refer to troubleshooting section in the | |
| owner's guide for the |
Manual Reset Procedure
In some cases, performing a reset on the MCD6 may resolve your problem. First try resetting the MCD6 player by pressing the TRACK UP and POWER buttons at the same time. If that does not work, remove the plastic front cover by pulling straight out and press the RESET button below the keypad. If your MCD6 player still does not operate, please contact your dealer or M&S Systems, Technical Support at (800)
7 8